[Intel-gfx] [PATCH 1/4] drm/i915/fbdev: Fix num_connector references in intel_fb_initial_config()

Lyude cpaul at redhat.com
Tue May 31 16:49:04 UTC 2016


commit 14a3842a1d5945067d1dd0788f314e14d5b18e5b upstream.

During boot time, MST devices usually send a ton of hotplug events
irregardless of whether or not any physical hotplugs actually occurred.
Hotplugs mean connectors being created/destroyed, and the number of DRM
connectors changing under us. This isn't a problem if we use
fb_helper->connector_count since we only set it once in the code,
however if we use num_connector from struct drm_mode_config we risk it's
value changing under us. On top of that, there's even a chance that
dev->mode_config.num_connector != fb_helper->connector_count. If the
number of connectors happens to increase under us, we'll end up using
the wrong array size for memcpy and start writing beyond the actual
length of the array, occasionally resulting in kernel panics.

This fix is only required for 4.6 and below. David Airlie's patchseries
for 4.7 to add connector reference counting provides a more proper fix
for this.

Upstream fix: 0552f7651bc2 ("drm/i915/mst: use reference counted
connectors. (v3)")
Reviewed-by: Daniel Vetter <daniel.vetter at ffwll.ch>
Signed-off-by: Lyude <cpaul at redhat.com>
---
 drivers/gpu/drm/i915/intel_fbdev.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_fbdev.c b/drivers/gpu/drm/i915/intel_fbdev.c
index 97a91e6..c607217 100644
--- a/drivers/gpu/drm/i915/intel_fbdev.c
+++ b/drivers/gpu/drm/i915/intel_fbdev.c
@@ -366,12 +366,12 @@ static bool intel_fb_initial_config(struct drm_fb_helper *fb_helper,
 	uint64_t conn_configured = 0, mask;
 	int pass = 0;
 
-	save_enabled = kcalloc(dev->mode_config.num_connector, sizeof(bool),
+	save_enabled = kcalloc(fb_helper->connector_count, sizeof(bool),
 			       GFP_KERNEL);
 	if (!save_enabled)
 		return false;
 
-	memcpy(save_enabled, enabled, dev->mode_config.num_connector);
+	memcpy(save_enabled, enabled, fb_helper->connector_count);
 	mask = (1 << fb_helper->connector_count) - 1;
 retry:
 	for (i = 0; i < fb_helper->connector_count; i++) {
@@ -510,7 +510,7 @@ retry:
 	if (fallback) {
 bail:
 		DRM_DEBUG_KMS("Not using firmware configuration\n");
-		memcpy(enabled, save_enabled, dev->mode_config.num_connector);
+		memcpy(enabled, save_enabled, fb_helper->connector_count);
 		kfree(save_enabled);
 		return false;
 	}
-- 
2.5.5



More information about the Intel-gfx mailing list