[Intel-gfx] [PATCH 11/14] drm/i915: Fallback to lower link rate and lane count during link training
Jim Bride
jim.bride at linux.intel.com
Fri Sep 2 20:01:42 UTC 2016
On Fri, Sep 02, 2016 at 07:52:53PM +0000, Pandiyan, Dhinakaran wrote:
> On Thu, 2016-09-01 at 15:08 -0700, Manasi Navare wrote:
> > According to the DisplayPort Spec, in case of Clock Recovery failure
> > the link training sequence should fall back to the lower link rate
> > followed by lower lane count until CR succeeds.
> > On CR success, the sequence proceeds with Channel EQ.
> > In case of Channel EQ failures, it should fallback to
> > lower link rate and lane count and start the CR phase again.
> >
> > Signed-off-by: Manasi Navare <manasi.d.navare at intel.com>
> > ---
> > drivers/gpu/drm/i915/intel_ddi.c | 109 +++++++++++++++++++++++---
> > drivers/gpu/drm/i915/intel_dp_link_training.c | 12 ++-
> > drivers/gpu/drm/i915/intel_drv.h | 4 +-
> > 3 files changed, 110 insertions(+), 15 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/i915/intel_ddi.c b/drivers/gpu/drm/i915/intel_ddi.c
> > index 67a6a0b..78d6687 100644
> > --- a/drivers/gpu/drm/i915/intel_ddi.c
> > +++ b/drivers/gpu/drm/i915/intel_ddi.c
> > @@ -1634,29 +1634,50 @@ void intel_ddi_clk_select(struct intel_encoder *encoder,
> > }
> > }
> >
> > -static void intel_ddi_pre_enable_dp(struct intel_encoder *encoder,
> > +static void intel_ddi_pre_enable_edp(struct intel_encoder *encoder,
> > int link_rate, uint32_t lane_count,
> > - struct intel_shared_dpll *pll,
> > - bool link_mst)
> > + struct intel_shared_dpll *pll)
> > {
> > struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
> > struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> > enum port port = intel_ddi_get_encoder_port(encoder);
> >
> > intel_dp_set_link_params(intel_dp, link_rate, lane_count,
> > - link_mst);
> > - if (encoder->type == INTEL_OUTPUT_EDP)
> > - intel_edp_panel_on(intel_dp);
> > + false);
> > +
> > + intel_edp_panel_on(intel_dp);
> >
> > intel_ddi_clk_select(encoder, pll);
> > intel_prepare_dp_ddi_buffers(encoder);
> > intel_ddi_init_dp_buf_reg(encoder);
> > intel_dp_sink_dpms(intel_dp, DRM_MODE_DPMS_ON);
> > intel_dp_start_link_train(intel_dp);
> > - if (port != PORT_A || INTEL_GEN(dev_priv) >= 9)
> > + if (port != PORT_A || INTEL_INFO(dev_priv)->gen >= 9)
> > intel_dp_stop_link_train(intel_dp);
> > }
> >
> > +static void intel_ddi_pre_enable_dp(struct intel_encoder *encoder,
> > + int link_rate, uint32_t lane_count,
> > + struct intel_shared_dpll *pll,
> > + bool link_mst)
> > +{
> > + struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
> > + struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> > + struct intel_shared_dpll_config tmp_pll_config;
> > +
> > + /* Disable the PLL and obtain the PLL for Link Training
> > + * that starts with highest link rate and lane count.
> > + */
> > + tmp_pll_config = pll->config;
> > + pll->funcs.disable(dev_priv, pll);
> > + pll->config.crtc_mask = 0;
> > +
> > + /* If Link Training fails, send a uevent to generate a hotplug */
> > + if (!(intel_ddi_link_train(intel_dp, link_rate, lane_count, link_mst)))
> > + drm_kms_helper_hotplug_event(encoder->base.dev);
> > + pll->config = tmp_pll_config;
> > +}
> > +
> > static void intel_ddi_pre_enable_hdmi(struct intel_encoder *encoder,
> > bool has_hdmi_sink,
> > struct drm_display_mode *adjusted_mode,
> > @@ -1690,20 +1711,26 @@ static void intel_ddi_pre_enable(struct intel_encoder *intel_encoder,
> > struct intel_crtc *crtc = to_intel_crtc(encoder->crtc);
> > int type = intel_encoder->type;
> >
> > - if (type == INTEL_OUTPUT_DP || type == INTEL_OUTPUT_EDP) {
> > + if (type == INTEL_OUTPUT_EDP)
> > + intel_ddi_pre_enable_edp(intel_encoder,
> > + crtc->config->port_clock,
> > + crtc->config->lane_count,
> > + crtc->config->shared_dpll);
> > +
> > + if (type == INTEL_OUTPUT_DP)
> > intel_ddi_pre_enable_dp(intel_encoder,
> > crtc->config->port_clock,
> > crtc->config->lane_count,
> > crtc->config->shared_dpll,
> > intel_crtc_has_type(crtc->config,
> > INTEL_OUTPUT_DP_MST));
> > - }
> > - if (type == INTEL_OUTPUT_HDMI) {
> > +
> > + if (type == INTEL_OUTPUT_HDMI)
> > intel_ddi_pre_enable_hdmi(intel_encoder,
> > crtc->config->has_hdmi_sink,
> > &crtc->config->base.adjusted_mode,
> > crtc->config->shared_dpll);
> > - }
> > +
> > }
> >
> > static void intel_ddi_post_disable(struct intel_encoder *intel_encoder,
> > @@ -2431,6 +2458,66 @@ intel_ddi_get_link_dpll(struct intel_dp *intel_dp, int clock)
> > return pll;
> > }
> >
> > +bool
> > +intel_ddi_link_train(struct intel_dp *intel_dp, int max_link_rate,
> > + uint8_t max_lane_count, bool link_mst)
> > +{
> > + struct intel_connector *connector = intel_dp->attached_connector;
> > + struct intel_encoder *encoder = connector->encoder;
> > + struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> > + struct intel_shared_dpll *pll;
> > + struct intel_shared_dpll_config tmp_pll_config;
> > + int link_rate;
> > + uint8_t lane_count;
> > + bool link_rate_not_found = true;
> > + bool ret = false;
> > +
> > + for (lane_count = max_lane_count; lane_count > 0; lane_count >>= 1) {
> > +
> > + link_rate = max_link_rate;
> > + while (link_rate_not_found) {
> > + pll = intel_ddi_get_link_dpll(intel_dp, link_rate);
> > + if (pll == NULL) {
> > + DRM_ERROR("Could not find DPLL for link "
> > + "training.\n");
> > + return false;
> > + }
> > + tmp_pll_config = pll->config;
> > + pll->funcs.enable(dev_priv, pll);
> > +
> > + intel_dp_set_link_params(intel_dp, link_rate,
> > + lane_count, link_mst);
> > +
> > + intel_ddi_clk_select(encoder, pll);
> > + intel_prepare_dp_ddi_buffers(encoder);
> > + intel_ddi_init_dp_buf_reg(encoder);
> > + intel_dp_sink_dpms(intel_dp, DRM_MODE_DPMS_ON);
> > + ret = intel_dp_start_link_train(intel_dp);
> > + if (ret)
> > + break;
> > +
> > + /* Disable port followed by PLL for next retry/clean up */
> > + intel_ddi_post_disable(encoder, NULL, NULL);
> > + pll->funcs.disable(dev_priv, pll);
> > + if (link_rate == 540000)
> > + link_rate = 270000;
> > + else if (link_rate == 270000)
> > + link_rate = 162000;
> > + else
> > + link_rate_not_found = false;
>
> 1. Aren't the supported rates platform dependent? I see these
> definitions in intel_dp.c
>
> static const int bxt_rates[] = { 162000, 216000, 243000, 270000,
> 324000, 432000, 540000 };
> static const int skl_rates[] = { 162000, 216000, 270000,
> 324000, 432000, 540000 };
>
>
> 2. Also, it is good to have the standard rates defined in a array within
> a header instead of having literals here.
>
> Or even better, re-use what's available in intel_dp.c
> static const int default_rates[] = { 162000, 270000, 540000 };
Actually, we should be fetching and using the common rates here. There's
already code to take the union of what the source and sink support.
Jim
>
> > + }
> > + if (ret) {
> > + DRM_DEBUG_KMS("Link Training successful\n");
> > + intel_dp_stop_link_train(intel_dp);
> > + break;
> > + }
> > + }
> > + if (!lane_count)
> > + DRM_ERROR("Link Training Failed\n");
> > +
> > + return ret;
> > +}
> > +
> > void intel_ddi_init(struct drm_device *dev, enum port port)
> > {
> > struct drm_i915_private *dev_priv = to_i915(dev);
> > diff --git a/drivers/gpu/drm/i915/intel_dp_link_training.c b/drivers/gpu/drm/i915/intel_dp_link_training.c
> > index 07f0159..0df49e8 100644
> > --- a/drivers/gpu/drm/i915/intel_dp_link_training.c
> > +++ b/drivers/gpu/drm/i915/intel_dp_link_training.c
> > @@ -309,9 +309,15 @@ void intel_dp_stop_link_train(struct intel_dp *intel_dp)
> > DP_TRAINING_PATTERN_DISABLE);
> > }
> >
> > -void
> > +bool
> > intel_dp_start_link_train(struct intel_dp *intel_dp)
> > {
> > - intel_dp_link_training_clock_recovery(intel_dp);
> > - intel_dp_link_training_channel_equalization(intel_dp);
> > + bool ret;
> > +
> > + if (intel_dp_link_training_clock_recovery(intel_dp)) {
> > + ret = intel_dp_link_training_channel_equalization(intel_dp);
> > + if (ret)
> > + return true;
> > + }
> > + return false;
> > }
> > diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
> > index e5bc976..342a2d5 100644
> > --- a/drivers/gpu/drm/i915/intel_drv.h
> > +++ b/drivers/gpu/drm/i915/intel_drv.h
> > @@ -1160,6 +1160,8 @@ void intel_ddi_clock_get(struct intel_encoder *encoder,
> > struct intel_crtc_state *pipe_config);
> > void intel_ddi_set_vc_payload_alloc(struct drm_crtc *crtc, bool state);
> > uint32_t ddi_signal_levels(struct intel_dp *intel_dp);
> > +bool intel_ddi_link_train(struct intel_dp *intel_dp, int max_link_rate,
> > + uint8_t max_lane_count, bool link_mst);
> > struct intel_shared_dpll *intel_ddi_get_link_dpll(struct intel_dp *intel_dp,
> > int clock);
> > unsigned int intel_fb_align_height(struct drm_device *dev,
> > @@ -1381,7 +1383,7 @@ bool intel_dp_init_connector(struct intel_digital_port *intel_dig_port,
> > void intel_dp_set_link_params(struct intel_dp *intel_dp,
> > int link_rate, uint8_t lane_count,
> > bool link_mst);
> > -void intel_dp_start_link_train(struct intel_dp *intel_dp);
> > +bool intel_dp_start_link_train(struct intel_dp *intel_dp);
> > void intel_dp_stop_link_train(struct intel_dp *intel_dp);
> > void intel_dp_sink_dpms(struct intel_dp *intel_dp, int mode);
> > void intel_dp_encoder_reset(struct drm_encoder *encoder);
>
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx
More information about the Intel-gfx
mailing list