[Intel-gfx] [PATCH v4 2/4] drm/i915/psr: Account for sink CRC raciness on some panels

[Pandiyan, Dhinakaran]

On Thu, 2017-08-03 at 11:07 -0700, Rodrigo Vivi wrote:
> On Tue, Jul 18, 2017 at 2:34 PM, Jim Bride <jim.bride at linux.intel.com> wrote:
> > According to the eDP spec, when the count field in TEST_SINK_MISC
> > increments then the six bytes of sink CRC information in the DPCD
> > should be valid.  Unfortunately, this doesn't seem to be the case
> > on some panels, and as a result we get some incorrect and inconsistent
> > values from the sink CRC DPCD locations at times.  This problem exhibits
> > itself more on faster processors (relative failure rates HSW < SKL < KBL.)
> > In order to try and account for this, we try a lot harder to read the sink
> > CRC until we get consistent values twice in a row before returning what we
> > read and delay for a time before trying to read.  We still see some
> > occasional failures, but reading the sink CRC is much more reliable,
> > particularly on SKL and KBL, with these changes than without.

I'm curious if we get the correct crc if we waited a full second.

> 
> Is DK now ok with this description?
> I believe he requested more info here.
> 
> >
> > v2: * Reduce number of retries when reading the sink CRC (Jani)
> >     * Refactor to minimize changes to the code (Jani)
> >     * Rebase
> > v3: * Rebase
> > v4: * Switch from do-while to for loop when reading CRC values (Jani)
> >     * Rebase
> > Cc: Rodrigo Vivi <rodrigo.vivi at intel.com>
> > Cc: Paulo Zanoni <paulo.r.zanoni at intel.com>
> > Cc: Jani Nikula <jani.nikula at intel.com>
> > Signed-off-by: Jim Bride <jim.bride at linux.intel.com>
> > ---
> >  drivers/gpu/drm/i915/intel_dp.c | 33 ++++++++++++++++++++++++++++++---
> >  1 file changed, 30 insertions(+), 3 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
> > index 2d42d09..c90ca1c 100644
> > --- a/drivers/gpu/drm/i915/intel_dp.c
> > +++ b/drivers/gpu/drm/i915/intel_dp.c
> > @@ -3906,6 +3906,11 @@ int intel_dp_sink_crc(struct intel_dp *intel_dp, u8 *crc)
> >         u8 buf;
> >         int count, ret;
> >         int attempts = 6;
> > +       u8 old_crc[6];
> > +
> > +       if (crc == NULL) {
> > +               return -ENOMEM;
> > +       }
> 
> wouldn't we drop this check per DK and Jani request?
> I believe we don't need it, but even if there are cases that we need
> we could remove the braces..
> 

Yeah, crc is allocated on the stack. If that is null, we'll have bigger
problems to deal with. And I think it's reasonable to assume the caller
is sending a valid array to fill data.

> >
> >         ret = intel_dp_sink_crc_start(intel_dp);
> >         if (ret)
> > @@ -3929,11 +3934,33 @@ int intel_dp_sink_crc(struct intel_dp *intel_dp, u8 *crc)
> >                 goto stop;
> >         }
> >
> > -       if (drm_dp_dpcd_read(&intel_dp->aux, DP_TEST_CRC_R_CR, crc, 6) < 0) {
> > -               ret = -EIO;
> > -               goto stop;
> > +       /*
> > +        * Sometimes it takes a while for the "real" CRC values to land in
> > +        * the DPCD, so try several times until we get two reads in a row
> > +        * that are the same.  If we're an eDP panel, delay between reads
> > +        * for a while since the values take a bit longer to propagate.
> > +        */
> > +       for (attempts = 0; attempts < 6; attempts++) {
> > +               intel_wait_for_vblank(dev_priv, intel_crtc->pipe);
> 
> DK, we need vblank wait because the crc calculation also may take one vblank.
> usually 2 actually... one to make sure you have the full screen
> updated and one for the calculation.
> In the past when we didn't used the count we were waiting 2 vblanks...
> 


Thanks for the clarification. My reasoning was, after the first two
vblank_waits for the sink to calculate crc, the ones in the retry path
were unnecessary. We just need some delay before reading the dpcd again
without having to enable vblank interrupts. Anyway, the number of
retries is low enough that it shouldn't matter.

On the other hand, since the only consumers of dp sink crc are tests,
why can't the kernel just dump what it reads to debugfs and let the test
deal with erroneous results?

> > +
> > +               if (drm_dp_dpcd_read(&intel_dp->aux, DP_TEST_CRC_R_CR,
> > +                                    crc, 6) < 0) {
> > +                       ret = -EIO;
> > +                       break;
> > +               }
> > +
> > +               if (attempts && memcmp(old_crc, crc, 6) == 0)
> > +                       break;
> > +               memcpy(old_crc, crc, 6);
> 
> little bikeshed: too many hardcoded "6" around... a sizeof would be better...
> but whatever...
> 
> > +
> > +               if (is_edp(intel_dp))
> > +                       usleep_range(20000, 25000);
> >         }
> >
> > +       if (attempts == 6) {
> > +               DRM_DEBUG_KMS("Failed to get CRC after 6 attempts.\n");
> > +               ret = -ETIMEDOUT;
> > +       }
> >  stop:
> >         intel_dp_sink_crc_stop(intel_dp);
> >         return ret;
> > --
> > 2.7.4
> >
> > _______________________________________________
> > Intel-gfx mailing list
> > Intel-gfx at lists.freedesktop.org
> > https://lists.freedesktop.org/mailman/listinfo/intel-gfx
> 
> 
>