[Intel-gfx] [PATCH v2 0/6] HDMI 2.0: Scrambling in DRM layer
Shashank Sharma
shashank.sharma at intel.com
Mon Feb 6 13:59:20 UTC 2017
HDMI 2.0 spec defines a method to reduce the RF footprint while
operating at higher pixel clocks, which is called Scrambling.
Scrambling can be controlled over a new set of I2C registers
which are accessible over existing DDC I2C lines, called SCDC
register set.
This patch series contains 6 patches:
- First two patches add generic drm helper functions to read and
write into SCDC registers. These patches are written by Thierry,
in a patch series published here:
https://patchwork.kernel.org/patch/9459051/
Minor changes were done to map the patches into this series.
- Next two patches add functions for scrambling detection and
scrambling control.
- Next two patches use this infrastructure in DRM layer From
I915 driver, to enable scrambling on a GLK deivce which sports
a native HDMI 2.0 controller.
V2:
- addressed review comments from Thierry, Ville and Dhinakaran
- added signed-off-by:self in first two patches(Jani N)
Shashank Sharma (4):
drm/edid: detect SCDC support in HF-VSDB
drm: scrambling support in drm layer
drm/i915: enable scrambling
drm/i915: allow HDMI 2.0 clock rates
Thierry Reding (2):
drm: Add SCDC helpers
drm/edid: check for HF-VSDB block
Documentation/gpu/drm-kms-helpers.rst | 12 ++
drivers/gpu/drm/Makefile | 3 +-
drivers/gpu/drm/drm_edid.c | 60 ++++++++++
drivers/gpu/drm/drm_scdc_helper.c | 211 ++++++++++++++++++++++++++++++++++
drivers/gpu/drm/i915/i915_reg.h | 2 +
drivers/gpu/drm/i915/intel_ddi.c | 26 +++++
drivers/gpu/drm/i915/intel_drv.h | 11 ++
drivers/gpu/drm/i915/intel_hdmi.c | 72 ++++++++++++
include/drm/drm_connector.h | 52 +++++++++
include/drm/drm_edid.h | 6 +-
include/drm/drm_scdc_helper.h | 152 ++++++++++++++++++++++++
include/linux/hdmi.h | 1 +
12 files changed, 606 insertions(+), 2 deletions(-)
create mode 100644 drivers/gpu/drm/drm_scdc_helper.c
create mode 100644 include/drm/drm_scdc_helper.h
--
1.9.1
More information about the Intel-gfx
mailing list