[Intel-gfx] [PATCH v2 04/10] drm/i915/dsi: Group DPOunit clock gate workaround with PLL enable
Hans de Goede
hdegoede at redhat.com
Tue Feb 28 12:59:19 UTC 2017
Move the DPOunit clock gate workaround to directly after the PLL enable.
The exact location of the workaround does not matter and there are 2
reasons to group it with the PLL enable:
1) This moves it out of the middle of the init sequence from the spec,
making it easier to follow the init sequence / compare it to the spec
2) It is grouped with the pll disable call in intel_dsi_post_disable,
so for consistency it should be grouped with the pll enable in
intel_dsi_pre_enable
Signed-off-by: Hans de Goede <hdegoede at redhat.com>
Reviewed-by: Bob Paauwe <bob.j.paauwe at intel.com>
---
drivers/gpu/drm/i915/intel_dsi.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
index aee1f2e..04fd01d 100644
--- a/drivers/gpu/drm/i915/intel_dsi.c
+++ b/drivers/gpu/drm/i915/intel_dsi.c
@@ -620,14 +620,6 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
I915_WRITE(BXT_P_DSI_REGULATOR_TX_CTRL, 0);
}
- intel_dsi_prepare(encoder, pipe_config);
-
- /* Power on, try both CRC pmic gpio and VBT */
- if (intel_dsi->gpio_panel)
- gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
- intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON);
- msleep(intel_dsi->panel_on_delay);
-
if (IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) {
u32 val;
@@ -637,6 +629,14 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
I915_WRITE(DSPCLK_GATE_D, val);
}
+ intel_dsi_prepare(encoder, pipe_config);
+
+ /* Power on, try both CRC pmic gpio and VBT */
+ if (intel_dsi->gpio_panel)
+ gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
+ intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON);
+ msleep(intel_dsi->panel_on_delay);
+
/* put device in ready state */
intel_dsi_device_ready(encoder);
--
2.9.3
More information about the Intel-gfx
mailing list