[Intel-gfx] [PATCH RESEND FOR CI 04/10] drm/i915/dsi: Group DPOunit clock gate workaround with PLL enable

Jani Nikula jani.nikula at intel.com
Wed Mar 1 13:15:00 UTC 2017


From: Hans de Goede <hdegoede at redhat.com>

Move the DPOunit clock gate workaround to directly after the PLL enable.

The exact location of the workaround does not matter and there are 2
reasons to group it with the PLL enable:

1) This moves it out of the middle of the init sequence from the spec,
   making it easier to follow the init sequence / compare it to the spec

2) It is grouped with the pll disable call in intel_dsi_post_disable,
   so for consistency it should be grouped with the pll enable in
   intel_dsi_pre_enable

Signed-off-by: Hans de Goede <hdegoede at redhat.com>
Reviewed-by: Bob Paauwe <bob.j.paauwe at intel.com>
Signed-off-by: Jani Nikula <jani.nikula at intel.com>
---
 drivers/gpu/drm/i915/intel_dsi.c | 16 ++++++++--------
 1 file changed, 8 insertions(+), 8 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
index ab905474b9dd..da798a579e11 100644
--- a/drivers/gpu/drm/i915/intel_dsi.c
+++ b/drivers/gpu/drm/i915/intel_dsi.c
@@ -791,14 +791,6 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
 		I915_WRITE(BXT_P_DSI_REGULATOR_TX_CTRL, 0);
 	}
 
-	intel_dsi_prepare(encoder, pipe_config);
-
-	/* Power on, try both CRC pmic gpio and VBT */
-	if (intel_dsi->gpio_panel)
-		gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
-	intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON);
-	msleep(intel_dsi->panel_on_delay);
-
 	if (IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) {
 		u32 val;
 
@@ -808,6 +800,14 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
 		I915_WRITE(DSPCLK_GATE_D, val);
 	}
 
+	intel_dsi_prepare(encoder, pipe_config);
+
+	/* Power on, try both CRC pmic gpio and VBT */
+	if (intel_dsi->gpio_panel)
+		gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
+	intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON);
+	msleep(intel_dsi->panel_on_delay);
+
 	/* put device in ready state */
 	intel_dsi_device_ready(encoder);
 
-- 
2.1.4



More information about the Intel-gfx mailing list