[Intel-gfx] [PATCH] drm/i915: sync dp link status checks against atomic commmits
Daniel Vetter
daniel at ffwll.ch
Wed Nov 8 13:28:23 UTC 2017
On Wed, Nov 08, 2017 at 03:26:15PM +0200, Ville Syrjälä wrote:
> On Wed, Nov 08, 2017 at 02:11:46PM +0100, Daniel Vetter wrote:
> > On Wed, Nov 08, 2017 at 03:04:58PM +0200, Ville Syrjälä wrote:
> > > On Wed, Nov 08, 2017 at 01:57:50PM +0100, Daniel Vetter wrote:
> > > > Two bits:
> > > > - check actual atomic state, the legacy stuff can only be looked at
> > > > from within the atomic_commit_tail function, since it's only
> > > > protected by ordering and not by any locks.
> > > >
> > > > - Make sure we don't wreak the work an ongoing nonblocking commit is
> > > > doing.
> > >
> > > I still think we need to move the retraining to the hotplug work.
> >
> > Why? One of the patch series Maarten mentioned says there's a deadlock
> > with dp aux, but it seems to be all just fine when CI retrains.
>
> I guess the deadlock is possible only with MST, maybe. Currently MST
> has it's own copy of the retraining code without the locks.
>
> At one point I started to rewrite the entire sink irq handling into a
> much nicer shape, also unifying the approach between MST and SST. IIRC
> I did still make the mistake of having some kind of higher level MST
> vs. SST split, but I think the proper solution is to combine the two
> almost entirely. I think we should even be using the ESI registers
> with SST for DPCD 1.2+. Currently we use ESI for MST and non-ESI for
> SST. Sadly I've not found the time to continue that work (same story
> with the "shutdown displays prior to rebooting to keep Dell MST
> monitors working" thing).
Yeah, merging sst and mst more definitely sounds like a good idea. I've
also been toying with it since forever.
> > And even if there is a deadlock, it's there already, so not sure why we
> > need to block this bugfix on a different bugfix. Which seems to be what
> > you're suggesting here (but it's a bit sparse).
>
> I guess what I'm really saying is that we shouldn't stop here.
Fully agreed.
-Daniel
>
> > -Daniel
> >
> > > > v2: We need the crtc lock too, because a plane update might change it
> > > > without having to acquire the connection_mutex (Maarten). Use
> > > > Maarten's changes for this locking, while keeping the logic that uses
> > > > the connection->commit->hw_done signal for syncing with nonblocking
> > > > commits.
> > > >
> > > > Cc: Manasi Navare <manasi.d.navare at intel.com>
> > > > Cc: Maarten Lankhorst <maarten.lankhorst at linux.intel.com>
> > > > Cc: Ville Syrjälä <ville.syrjala at linux.intel.com>
> > > > References: https://bugs.freedesktop.org/show_bug.cgi?id=103336
> > > > Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=99272
> > > > Signed-off-by: Daniel Vetter <daniel.vetter at intel.com>
> > > > ---
> > > > drivers/gpu/drm/i915/intel_dp.c | 56 ++++++++++++++++++++++++++++++++++++-----
> > > > 1 file changed, 50 insertions(+), 6 deletions(-)
> > > >
> > > > diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
> > > > index d27c0145ac91..7cd7ab4fb431 100644
> > > > --- a/drivers/gpu/drm/i915/intel_dp.c
> > > > +++ b/drivers/gpu/drm/i915/intel_dp.c
> > > > @@ -4319,6 +4319,8 @@ static void
> > > > intel_dp_check_link_status(struct intel_dp *intel_dp)
> > > > {
> > > > struct intel_encoder *intel_encoder = &dp_to_dig_port(intel_dp)->base;
> > > > + struct drm_connector_state *conn_state =
> > > > + intel_dp->attached_connector->base.state;
> > > > struct drm_device *dev = intel_dp_to_dev(intel_dp);
> > > > u8 link_status[DP_LINK_STATUS_SIZE];
> > > >
> > > > @@ -4329,10 +4331,15 @@ intel_dp_check_link_status(struct intel_dp *intel_dp)
> > > > return;
> > > > }
> > > >
> > > > - if (!intel_encoder->base.crtc)
> > > > + if (!conn_state->crtc)
> > > > return;
> > > >
> > > > - if (!to_intel_crtc(intel_encoder->base.crtc)->active)
> > > > + WARN_ON(!drm_modeset_is_locked(&conn_state->crtc->mutex));
> > > > +
> > > > + if (!conn_state->crtc->state->active)
> > > > + return;
> > > > +
> > > > + if (!try_wait_for_completion(&conn_state->commit->hw_done))
> > > > return;
> > > >
> > > > /*
> > > > @@ -4368,7 +4375,6 @@ intel_dp_check_link_status(struct intel_dp *intel_dp)
> > > > static bool
> > > > intel_dp_short_pulse(struct intel_dp *intel_dp)
> > > > {
> > > > - struct drm_device *dev = intel_dp_to_dev(intel_dp);
> > > > struct intel_encoder *intel_encoder = &dp_to_dig_port(intel_dp)->base;
> > > > u8 sink_irq_vector = 0;
> > > > u8 old_sink_count = intel_dp->sink_count;
> > > > @@ -4408,9 +4414,8 @@ intel_dp_short_pulse(struct intel_dp *intel_dp)
> > > > DRM_DEBUG_DRIVER("CP or sink specific irq unhandled\n");
> > > > }
> > > >
> > > > - drm_modeset_lock(&dev->mode_config.connection_mutex, NULL);
> > > > intel_dp_check_link_status(intel_dp);
> > > > - drm_modeset_unlock(&dev->mode_config.connection_mutex);
> > > > +
> > > > if (intel_dp->compliance.test_type == DP_TEST_LINK_TRAINING) {
> > > > DRM_DEBUG_KMS("Link Training Compliance Test requested\n");
> > > > /* Send a Hotplug Uevent to userspace to start modeset */
> > > > @@ -4860,8 +4865,19 @@ intel_dp_detect(struct drm_connector *connector,
> > > > connector->base.id, connector->name);
> > > >
> > > > /* If full detect is not performed yet, do a full detect */
> > > > - if (!intel_dp->detect_done)
> > > > + if (!intel_dp->detect_done) {
> > > > + struct drm_crtc *crtc;
> > > > + int ret;
> > > > +
> > > > + crtc = connector->state->crtc;
> > > > + if (crtc) {
> > > > + ret = drm_modeset_lock(&crtc->mutex, ctx);
> > > > + if (ret)
> > > > + return ret;
> > > > + }
> > > > +
> > > > status = intel_dp_long_pulse(intel_dp->attached_connector);
> > > > + }
> > > >
> > > > intel_dp->detect_done = false;
> > > >
> > > > @@ -5146,10 +5162,38 @@ intel_dp_hpd_pulse(struct intel_digital_port *intel_dig_port, bool long_hpd)
> > > > }
> > > >
> > > > if (!intel_dp->is_mst) {
> > > > + struct drm_modeset_acquire_ctx ctx;
> > > > + struct drm_connector *connector = &intel_dp->attached_connector->base;
> > > > + struct drm_crtc *crtc;
> > > > + int iret;
> > > > +
> > > > + drm_modeset_acquire_init(&ctx, 0);
> > > > +retry:
> > > > + iret = drm_modeset_lock(&dev->mode_config.connection_mutex, &ctx);
> > > > + if (iret)
> > > > + goto err;
> > > > +
> > > > + crtc = connector->state->crtc;
> > > > + if (crtc) {
> > > > + iret = drm_modeset_lock(&crtc->mutex, &ctx);
> > > > + if (iret)
> > > > + goto err;
> > > > + }
> > > > +
> > > > if (!intel_dp_short_pulse(intel_dp)) {
> > > > intel_dp->detect_done = false;
> > > > goto put_power;
> > > > }
> > > > +
> > > > +err:
> > > > + if (iret == -EDEADLK) {
> > > > + drm_modeset_backoff(&ctx);
> > > > + goto retry;
> > > > + }
> > > > +
> > > > + drm_modeset_drop_locks(&ctx);
> > > > + drm_modeset_acquire_fini(&ctx);
> > > > + WARN(iret, "Acquiring modeset locks failed with %i\n", iret);
> > > > }
> > > >
> > > > ret = IRQ_HANDLED;
> > > > --
> > > > 2.15.0
> > >
> > > --
> > > Ville Syrjälä
> > > Intel OTC
> >
> > --
> > Daniel Vetter
> > Software Engineer, Intel Corporation
> > http://blog.ffwll.ch
>
> --
> Ville Syrjälä
> Intel OTC
--
Daniel Vetter
Software Engineer, Intel Corporation
http://blog.ffwll.ch
More information about the Intel-gfx
mailing list