[Intel-gfx] [PATCH i-g-t v3 1/2] tests/debugfs_test: Try to light all outputs to increase chances of finding fails, v3.
Maarten Lankhorst
maarten.lankhorst at linux.intel.com
Thu Oct 12 10:47:54 UTC 2017
Make sure read_all_entries has all outputs possible enabled, but also
add a test that runs with all outputs disabled.
This will maximize coverage of debugfs reading, and allows the test not
to be dependent on fbcon for setup.
Changes since v1:
- Put framebuffers on all primary planes, to get a crc from i915_sink_src_eDP1.
Changes since v2:
- Use igt_output_get_plane_type, not igt_output_get_plane.
Signed-off-by: Maarten Lankhorst <maarten.lankhorst at linux.intel.com>
Reviewed-by: Chris Wilson <chris at chris-wilson.co.uk> #v1
---
tests/debugfs_test.c | 50 ++++++++++++++++++++++++++++++++++++++++++++++++++
1 file changed, 50 insertions(+)
diff --git a/tests/debugfs_test.c b/tests/debugfs_test.c
index 5e7805e1559e..c4f43a65b61b 100644
--- a/tests/debugfs_test.c
+++ b/tests/debugfs_test.c
@@ -78,15 +78,64 @@ static void read_and_discard_sysfs_entries(int path_fd)
igt_main
{
int fd = -1, debugfs;
+ igt_display_t display;
+ struct igt_fb fb[IGT_MAX_PIPES];
+ enum pipe pipe;
+
igt_skip_on_simulation();
igt_fixture {
fd = drm_open_driver_master(DRIVER_INTEL);
igt_require_gem(fd);
debugfs = igt_debugfs_dir(fd);
+
+ kmstest_set_vt_graphics_mode();
+ igt_display_init(&display, fd);
}
igt_subtest("read_all_entries") {
+ /* try to light all pipes */
+ for_each_pipe(&display, pipe) {
+ igt_output_t *output;
+
+ for_each_valid_output_on_pipe(&display, pipe, output) {
+ igt_plane_t *primary;
+ drmModeModeInfo *mode;
+
+ if (output->pending_pipe != PIPE_NONE)
+ continue;
+
+ igt_output_set_pipe(output, pipe);
+ primary = igt_output_get_plane_type(output, DRM_PLANE_TYPE_PRIMARY);
+ mode = igt_output_get_mode(output);
+ igt_create_pattern_fb(display.drm_fd,
+ mode->hdisplay, mode->vdisplay,
+ DRM_FORMAT_XRGB8888,
+ LOCAL_DRM_FORMAT_MOD_NONE, &fb[pipe]);
+
+ igt_plane_set_fb(primary, &fb[pipe]);
+ break;
+ }
+ }
+
+ igt_display_commit2(&display, display.is_atomic ? COMMIT_ATOMIC : COMMIT_LEGACY);
+
+ read_and_discard_sysfs_entries(debugfs);
+ }
+
+ igt_subtest("read_all_entries_display_off") {
+ igt_output_t *output;
+ igt_plane_t *plane;
+
+ for_each_connected_output(&display, output)
+ igt_output_set_pipe(output, PIPE_NONE);
+
+ for_each_pipe(&display, pipe)
+ for_each_plane_on_pipe(&display, pipe, plane)
+ igt_plane_set_fb(plane, NULL);
+
+ igt_display_commit2(&display, display.is_atomic ? COMMIT_ATOMIC : COMMIT_LEGACY);
+
read_and_discard_sysfs_entries(debugfs);
}
@@ -112,6 +161,7 @@ igt_main
}
igt_fixture {
+ igt_display_fini(&display);
close(debugfs);
close(fd);
}
--
2.14.1
More information about the Intel-gfx
mailing list