[Intel-gfx] [PATCH v4 1/3] drm/i915/gvt: Add gvt_debug in i915_params for GVT-g log classification
Joonas Lahtinen
joonas.lahtinen at linux.intel.com
Tue Sep 19 09:11:28 UTC 2017
The title should begin with "drm/i915:" not "drm/i915/gvt:".
On Tue, 2017-09-19 at 15:54 +0800, Shuo Liu wrote:
Commit message is always needed.
> Signed-off-by: Shuo Liu <shuo.a.liu at intel.com>
<SNIP>
> @@ -65,6 +65,7 @@ struct i915_params i915 __read_mostly = {
> .inject_load_failure = 0,
> .enable_dpcd_backlight = false,
> .enable_gvt = false,
> + .debug_gvt = 0,
Let's try to keep the struct ordered.
> @@ -257,3 +258,15 @@ struct i915_params i915 __read_mostly = {
> module_param_named(enable_gvt, i915.enable_gvt, bool, 0400);
> MODULE_PARM_DESC(enable_gvt,
> "Enable support for Intel GVT-g graphics virtualization host support(default:false)");
> +
> +module_param_named(debug_gvt, i915.debug_gvt, int, 0600);
> +MODULE_PARM_DESC(debug_gvt, "Enable GVT-g debug output, where each bit enables a category.\n"
> + "\t\tBit 0 (0x01) will enable CORE messages (GVT-g core message)\n"
> + "\t\tBit 1 (0x02) will enable IRQ messages (GVT-g interrupt message)\n"
> + "\t\tBit 2 (0x04) will enable MM messages (GVT-g memory management message)\n"
> + "\t\tBit 3 (0x08) will enable MMIO messages (GVT-g MMIO message)\n"
> + "\t\tBit 4 (0x10) will enable DPY messages (GVT-g display message)\n"
> + "\t\tBit 5 (0x20) will enable EL messages (GVT-g execlist message)\n"
> + "\t\tBit 6 (0x40) will enable SCHED messages (GVT-g schedule message)\n"
> + "\t\tBit 7 (0x80) will enable RENDER messages (GVT-g render message)\n"
> + "\t\tBit 8 (0x100) will enable CMD messages (GVT-g command message)");
s/message/code/ for the description in braces, like the drm
counterpart. Or change them to be just "GVT-g core", "GVT-g
scheduling", "GVT-g commands" etc.
One tab indent is enough like mostly used in the file.
Regards, Joonas
--
Joonas Lahtinen
Open Source Technology Center
Intel Corporation
More information about the Intel-gfx
mailing list