[Intel-gfx] [PATCH v11 1/2] drm/i915: Implement WaProgramMgsrForCorrectSliceSpecificMmioReads

Oscar Mateo oscar.mateo at intel.com
Wed Apr 18 22:12:49 UTC 2018



On 4/18/2018 3:01 PM, Yunwei Zhang wrote:
> WaProgramMgsrForCorrectSliceSpecificMmioReads dictate that before any MMIO
> read into Slice/Subslice specific registers, MCR packet control
> register(0xFDC) needs to be programmed to point to any enabled
> slice/subslice pair. Otherwise, incorrect value will be returned.
>
> However, that means each subsequent MMIO read will be forwarded to a
> specific slice/subslice combination as read is unicast. This is OK since
> slice/subslice specific register values are consistent in almost all cases
> across slice/subslice. There are rare occasions such as INSTDONE that this
> value will be dependent on slice/subslice combo, in such cases, we need to
> program 0xFDC and recover this after. This is already covered by
> read_subslice_reg.
>
> Also, 0xFDC will lose its information after TDR/engine reset/power state
> change.
>
> References: HSD#1405586840, BSID#0575
>
> v2:
>   - use fls() instead of find_last_bit() (Chris)
>   - added INTEL_SSEU to extract sseu from device info. (Chris)
> v3:
>   - rebase on latest tip
> v5:
>   - Added references (Mika)
>   - Change the ordered of passing arguments and etc. (Ursulin)
> v7:
>   - Rebased.
> v8:
>   - Reviewed by Oscar
>   - Store default MCR value instead of calculate on the run. (Oscar)
> v9:
>   - Changed naming and label fixes. (Oscar)
>   - Store only the selector instead of whole MCR. (Oscar)
> v10:
>   - Improved comments, naming and line breaknig. (Oscar)
> v11:
>   - Moved the comment to most relavent block. (Oscar)
>
> Cc: Oscar Mateo <oscar.mateo at intel.com>
> Cc: Michel Thierry <michel.thierry at intel.com>
> Cc: Joonas Lahtinen <joonas.lahtinen at linux.intel.com>
> Cc: Chris Wilson <chris at chris-wilson.co.uk>
> Cc: Mika Kuoppala <mika.kuoppala at linux.intel.com>
> Cc: Tvrtko Ursulin <tvrtko.ursulin at linux.intel.com>
> Signed-off-by: Yunwei Zhang <yunwei.zhang at intel.com>
> Reviewed-by: Oscar Mateo <oscar.mateo at intel.com>
> ---
>   drivers/gpu/drm/i915/intel_device_info.c | 47 ++++++++++++++++++++++++++++++++
>   drivers/gpu/drm/i915/intel_device_info.h |  3 ++
>   drivers/gpu/drm/i915/intel_engine_cs.c   | 10 +++----
>   3 files changed, 55 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_device_info.c b/drivers/gpu/drm/i915/intel_device_info.c
> index a32ba72..ea62d45 100644
> --- a/drivers/gpu/drm/i915/intel_device_info.c
> +++ b/drivers/gpu/drm/i915/intel_device_info.c
> @@ -719,6 +719,51 @@ static u32 read_timestamp_frequency(struct drm_i915_private *dev_priv)
>   	return 0;
>   }
>   
> +
> +static void sanitize_mcr(struct intel_device_info *info)
> +{
> +	struct drm_i915_private *dev_priv =
> +		container_of(info, struct drm_i915_private, info);
> +	u32 mcr;
> +	u32 mcr_slice_subslice_mask;
> +	u32 mcr_slice_subslice_select;
> +	u32 slice = fls(info->sseu.slice_mask);
> +	u32 subslice = fls(info->sseu.subslice_mask[slice]);
> +
> +	if (INTEL_GEN(dev_priv) >= 11) {
> +		mcr_slice_subslice_mask = GEN11_MCR_SLICE_MASK |
> +					  GEN11_MCR_SUBSLICE_MASK;
> +		mcr_slice_subslice_select = GEN11_MCR_SLICE(slice) |
> +						GEN11_MCR_SUBSLICE(subslice);
> +	} else {
> +		mcr_slice_subslice_mask = GEN8_MCR_SLICE_MASK |
> +					  GEN8_MCR_SUBSLICE_MASK;
> +		mcr_slice_subslice_select = GEN8_MCR_SLICE(slice) |
> +						GEN8_MCR_SUBSLICE(subslice);
> +	}
> +
> +	mcr = I915_READ(GEN8_MCR_SELECTOR);
> +	mcr &= ~mcr_slice_subslice_mask;
> +
> +	/*
> +	 * WaProgramMgsrForCorrectSliceSpecificMmioReads:cnl,icl
> +	 * Before any MMIO read into slice/subslice specific registers, MCR
> +	 * packet control register needs to be programmed to point to any
> +	 * enabled s/ss pair. Otherwise, incorrect values will be returned.
> +	 * This means each subsequent MMIO read will be forwarded to an
> +	 * specific s/ss combination, but this is OK since these registers
> +	 * are consistent across s/ss in almost all cases. In the rare
> +	 * occasions, such as INSTDONE, where this value is dependent
> +	 * on s/ss combo, the read should be done with read_subslice_reg.
> +	 */
> +	if (INTEL_GEN(dev_priv) >= 10)
> +		mcr |= mcr_slice_subslice_select;
> +
> +	I915_WRITE(GEN8_MCR_SELECTOR, mcr);
> +
> +	info->default_mcr_s_ss_select = mcr_slice_subslice_select;

Sorry: forget my r-b, this is broken. For GENs that do not need the WA, 
info->default_mcr_s_ss_select should be 0

> +}
> +
>   /**
>    * intel_device_info_runtime_init - initialize runtime info
>    * @info: intel device info struct
> @@ -851,6 +896,8 @@ void intel_device_info_runtime_init(struct intel_device_info *info)
>   	else if (INTEL_INFO(dev_priv)->gen >= 11)
>   		gen11_sseu_info_init(dev_priv);
>   
> +	sanitize_mcr(info);
> +
>   	/* Initialize command stream timestamp frequency */
>   	info->cs_timestamp_frequency_khz = read_timestamp_frequency(dev_priv);
>   }
> diff --git a/drivers/gpu/drm/i915/intel_device_info.h b/drivers/gpu/drm/i915/intel_device_info.h
> index 933e316..2feccee 100644
> --- a/drivers/gpu/drm/i915/intel_device_info.h
> +++ b/drivers/gpu/drm/i915/intel_device_info.h
> @@ -176,6 +176,9 @@ struct intel_device_info {
>   	/* Slice/subslice/EU info */
>   	struct sseu_dev_info sseu;
>   
> +	/* default selected slice/subslice in MCR packet control */
> +	u32 default_mcr_s_ss_select;
> +
>   	u32 cs_timestamp_frequency_khz;
>   
>   	struct color_luts {
> diff --git a/drivers/gpu/drm/i915/intel_engine_cs.c b/drivers/gpu/drm/i915/intel_engine_cs.c
> index 1a83707..2b24277 100644
> --- a/drivers/gpu/drm/i915/intel_engine_cs.c
> +++ b/drivers/gpu/drm/i915/intel_engine_cs.c
> @@ -831,11 +831,9 @@ read_subslice_reg(struct drm_i915_private *dev_priv, int slice,
>   	intel_uncore_forcewake_get__locked(dev_priv, fw_domains);
>   
>   	mcr = I915_READ_FW(GEN8_MCR_SELECTOR);
> -	/*
> -	 * The HW expects the slice and sublice selectors to be reset to 0
> -	 * after reading out the registers.
> -	 */
> -	WARN_ON_ONCE(mcr & mcr_slice_subslice_mask);
> +
> +	WARN_ON_ONCE((mcr & mcr_slice_subslice_mask) !=
> +		      dev_priv->info.default_mcr_s_ss_select);
>   	mcr &= ~mcr_slice_subslice_mask;
>   	mcr |= mcr_slice_subslice_select;
>   	I915_WRITE_FW(GEN8_MCR_SELECTOR, mcr);
> @@ -843,6 +841,8 @@ read_subslice_reg(struct drm_i915_private *dev_priv, int slice,
>   	ret = I915_READ_FW(reg);
>   
>   	mcr &= ~mcr_slice_subslice_mask;
> +	mcr |= dev_priv->info.default_mcr_s_ss_select;
> +
>   	I915_WRITE_FW(GEN8_MCR_SELECTOR, mcr);
>   
>   	intel_uncore_forcewake_put__locked(dev_priv, fw_domains);



More information about the Intel-gfx mailing list