[Intel-gfx] [PATCH 26/24] drm/i915/icl: Add allowed DP rates for Icelake

[Paulo Zanoni]

From: Manasi Navare <manasi.d.navare at intel.com>

For ICL, on Combo PHY the allowed max rates are:
 - HBR3 8.1 eDP (DDIA)
 - HBR2 5.4 DisplayPort (DDIB)
and for MG PHY/TC DDI Ports allowed DP rates are:
 - HBR3 8.1 DisplayPort (DP alternate mode, DP over TBT,
 - DP on legacy connector - DDIC/D/E/F)

Cc: Rodrigo Vivi <rodrigo.vivi at intel.com>
Cc: Jani Nikula <jani.nikula at linux.intel.com>
Cc: James Ausmus <james.ausmus at intel.com>
Signed-off-by: Manasi Navare <manasi.d.navare at intel.com>
Signed-off-by: James Ausmus <james.ausmus at intel.com>
---
 drivers/gpu/drm/i915/intel_dp.c | 21 +++++++++++++++++++--
 1 file changed, 19 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index 5109023abe28..3ee8e74cf2b8 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -419,6 +419,20 @@ static int cnl_max_source_rate(struct intel_dp *intel_dp)
 	return 810000;
 }
 
+static int icl_max_source_rate(struct intel_dp *intel_dp)
+{
+	struct intel_digital_port *dig_port = dp_to_dig_port(intel_dp);
+	enum port port = dig_port->base.port;
+
+	/* On Combo PHY port A max speed is HBR3 for all Vccio voltages
+	 * and on Combo PHY Port B the maximum supported is HBR2.
+	 */
+	if (port == PORT_B)
+		return 540000;
+
+	return 810000;
+}
+
 static void
 intel_dp_set_source_rates(struct intel_dp *intel_dp)
 {
@@ -448,10 +462,13 @@ intel_dp_set_source_rates(struct intel_dp *intel_dp)
 	/* This should only be done once */
 	WARN_ON(intel_dp->source_rates || intel_dp->num_source_rates);
 
-	if (IS_CANNONLAKE(dev_priv)) {
+	if (INTEL_GEN(dev_priv) >= 10) {
 		source_rates = cnl_rates;
 		size = ARRAY_SIZE(cnl_rates);
-		max_rate = cnl_max_source_rate(intel_dp);
+		if (IS_ICELAKE(dev_priv))
+			max_rate = icl_max_source_rate(intel_dp);
+		else
+			max_rate = cnl_max_source_rate(intel_dp);
 	} else if (IS_GEN9_LP(dev_priv)) {
 		source_rates = bxt_rates;
 		size = ARRAY_SIZE(bxt_rates);
-- 
2.14.3