[Intel-gfx] ✗ Fi.CI.BAT: failure for More ICL display patches (rev11)

[Patchwork]

== Series Details ==

Series: More ICL display patches (rev11)
URL   : https://patchwork.freedesktop.org/series/43546/
State : failure

== Summary ==

Applying: drm/i915/icl: Extend AUX F interrupts to ICL
Applying: drm/i915/icl: GSE interrupt moves from DE_MISC to GU_MISC
Applying: drm/i915/icl: introduce tc_port
Applying: drm/i915/icl: Support for TC North Display interrupts
Applying: drm/i915/icp: Add Interrupt Support
Applying: drm/i915/icl: Add register definition for DFLEXDPMLE
Applying: drm/i915/icl: Add DDI HDMI level selection for ICL
Applying: drm/i915/icl: Map VBT DDC Pin to BSpec DDC Pin
Applying: drm/i915/icl: Add Icelake PCH detection
Applying: drm/i915/icl: add icelake_get_ddi_pll()
Applying: drm/i915/icl: Get DDI clock for ICL based on PLLs.
Applying: drm/i915/icl: Calculate link clock using the new registers
Applying: drm/i915/icl: unconditionally init DDI for every port
Applying: drm/i915/icl: start adding the TBT pll
Applying: drm/i915/icl: compute the TBT PLL registers
Applying: drm/i915/icl: Handle hotplug interrupts for DP over TBT
Applying: drm/i915/icl: Add 10-bit support for hdmi
Applying: drm/i915/icl: implement icl_digital_port_connected()
Applying: drm/i915/icl: store the port type for TC ports
Applying: drm/i915/icl: implement the tc/legacy HPD {dis, }connect flow for DP
Applying: drm/i915/icl: implement the legacy HPD {dis, }connect flow for HDMI
Applying: drm/i915/icl: Update FIA supported lane count for hpd.
Applying: drm/i915/icl: program MG_DP_MODE
Applying: drm/i915/icl: toggle PHY clock gating around link training
Applying: drm/i915/icl: fix gmbus gpio pin mapping
error: Failed to merge in the changes.
Using index info to reconstruct a base tree...
M	drivers/gpu/drm/i915/i915_reg.h
Falling back to patching base and 3-way merge...
Auto-merging drivers/gpu/drm/i915/i915_reg.h
CONFLICT (content): Merge conflict in drivers/gpu/drm/i915/i915_reg.h
Patch failed at 0025 drm/i915/icl: fix gmbus gpio pin mapping
The copy of the patch that failed is found in: .git/rebase-apply/patch
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".