[Intel-gfx] [PATCH] drm/i915/ringbuffer: Delay after EMIT_INVALIDATE for gen4/gen5
Chris Wilson
chris at chris-wilson.co.uk
Mon Nov 5 09:43:05 UTC 2018
Exercising the gpu reloc path strenuously revealed an issue where the
updated relocations (from MI_STORE_DWORD_IMM) were not being observed
upon execution. After some experiments with adding pipecontrols (a lot
of pipecontrols (32) as gen4/5 do not have a bit to wait on earlier pipe
controls or even the current on), it was discovered that we merely
needed to delay the EMIT_INVALIDATE by several flushes. It is important
to note that it is the EMIT_INVALIDATE as opposed to the EMIT_FLUSH that
needs the delay as opposed to what one might first expect -- that the
delay is required for the TLB invalidation to take effect (one presumes
to purge any CS buffers) as opposed to a delay after flushing to ensure
the writes have landed before triggering invalidation.
Testcase: igt/gem_tiled_fence_blits
Signed-off-by: Chris Wilson <chris at chris-wilson.co.uk>
Cc: stable at vger.kernel.org
---
drivers/gpu/drm/i915/intel_ringbuffer.c | 38 +++++++++++++++++++++++--
1 file changed, 36 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_ringbuffer.c b/drivers/gpu/drm/i915/intel_ringbuffer.c
index b8a7a014d46d..87eebc13c0d8 100644
--- a/drivers/gpu/drm/i915/intel_ringbuffer.c
+++ b/drivers/gpu/drm/i915/intel_ringbuffer.c
@@ -91,6 +91,7 @@ static int
gen4_render_ring_flush(struct i915_request *rq, u32 mode)
{
u32 cmd, *cs;
+ int i;
/*
* read/write caches:
@@ -127,12 +128,45 @@ gen4_render_ring_flush(struct i915_request *rq, u32 mode)
cmd |= MI_INVALIDATE_ISP;
}
- cs = intel_ring_begin(rq, 2);
+ i = 2;
+ if (mode & EMIT_INVALIDATE)
+ i += 20;
+
+ cs = intel_ring_begin(rq, i);
if (IS_ERR(cs))
return PTR_ERR(cs);
*cs++ = cmd;
- *cs++ = MI_NOOP;
+
+ /*
+ * A random delay to let the CS invalidate take effect? Without this
+ * delay, the GPU relocation path fails as the CS does not see
+ * the updated contents. Just as important, if we apply the flushes
+ * to the EMIT_FLUSH branch (i.e. immediately after the relocation
+ * write and before the invalidate on the next batch), the relocations
+ * still fail. This implies that is a delay following invalidation
+ * that is required to reset the caches as opposed to a delay to
+ * ensure the memory is written.
+ */
+ if (mode & EMIT_INVALIDATE) {
+ *cs++ = GFX_OP_PIPE_CONTROL(4) | PIPE_CONTROL_QW_WRITE;
+ *cs++ = i915_ggtt_offset(rq->engine->scratch) |
+ PIPE_CONTROL_GLOBAL_GTT;
+ *cs++ = 0;
+ *cs++ = 0;
+
+ for (i = 0; i < 12; i++)
+ *cs++ = MI_FLUSH;
+
+ *cs++ = GFX_OP_PIPE_CONTROL(4) | PIPE_CONTROL_QW_WRITE;
+ *cs++ = i915_ggtt_offset(rq->engine->scratch) |
+ PIPE_CONTROL_GLOBAL_GTT;
+ *cs++ = 0;
+ *cs++ = 0;
+ }
+
+ *cs++ = cmd;
+
intel_ring_advance(rq, cs);
return 0;
--
2.19.1
More information about the Intel-gfx
mailing list