[Intel-gfx] [PATCH v2 04/15] pwm: lpss: Fix off by one error in base_unit math in pwm_lpss_prepare()

[Hans de Goede]

According to the data-sheet the way the PWM controller works is that
each input clock-cycle the base_unit gets added to a N bit counter and
that counter overflowing determines the PWM output frequency.

So assuming e.g. a 16 bit counter this means that if base_unit is set to 1,
after 65535 input clock-cycles the counter has been increased from 0 to
65535 and it will overflow on the next cycle, so it will overflow after
every 65536 clock cycles and thus the calculations done in
pwm_lpss_prepare() should use 65536 and not 65535.

This commit fixes this. Note this also aligns the calculations in
pwm_lpss_prepare() with those in pwm_lpss_get_state().

Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
 drivers/pwm/pwm-lpss.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pwm/pwm-lpss.c b/drivers/pwm/pwm-lpss.c
index cae74ce61654..a764e062103b 100644
--- a/drivers/pwm/pwm-lpss.c
+++ b/drivers/pwm/pwm-lpss.c
@@ -93,7 +93,7 @@ static void pwm_lpss_prepare(struct pwm_lpss_chip *lpwm, struct pwm_device *pwm,
 	 * The equation is:
 	 * base_unit = round(base_unit_range * freq / c)
 	 */
-	base_unit_range = BIT(lpwm->info->base_unit_bits) - 1;
+	base_unit_range = BIT(lpwm->info->base_unit_bits);
 	freq *= base_unit_range;
 
 	base_unit = DIV_ROUND_CLOSEST_ULL(freq, c);
@@ -112,7 +112,7 @@ static void pwm_lpss_prepare(struct pwm_lpss_chip *lpwm, struct pwm_device *pwm,
 
 	orig_ctrl = ctrl = pwm_lpss_read(pwm);
 	ctrl &= ~PWM_ON_TIME_DIV_MASK;
-	ctrl &= ~(base_unit_range << PWM_BASE_UNIT_SHIFT);
+	ctrl &= ~((base_unit_range - 1) << PWM_BASE_UNIT_SHIFT);
 	ctrl |= (u32) base_unit << PWM_BASE_UNIT_SHIFT;
 	ctrl |= on_time_div;
 
-- 
2.26.2