[Intel-gfx] [v4] drm/i915/dsi: Send proper brightness value via MIPI DCS command

[Jani Nikula]

On Fri, 13 Aug 2021, Lee Shawn C <shawn.c.lee at intel.com> wrote:
> Driver has to swap the endian before send brightness level value
> to tcon.
>
> v2: Use __be16 instead of u16 to fix sparse warning.
>
> Reported-by: kernel test robot <lkp at intel.com>
> Cc: Ville Syrjala <ville.syrjala at linux.intel.com>
> Cc: Jani Nikula <jani.nikula at linux.intel.com>
> Cc: Vandita Kulkarni <vandita.kulkarni at intel.com>
> Cc: Cooper Chiou <cooper.chiou at intel.com>
> Cc: William Tseng <william.tseng at intel.com>
> Signed-off-by: Lee Shawn C <shawn.c.lee at intel.com>
> ---
>  drivers/gpu/drm/i915/display/intel_dsi_dcs_backlight.c | 3 +--
>  1 file changed, 1 insertion(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_dsi_dcs_backlight.c b/drivers/gpu/drm/i915/display/intel_dsi_dcs_backlight.c
> index cd85520d36e2..71c2adfa8931 100644
> --- a/drivers/gpu/drm/i915/display/intel_dsi_dcs_backlight.c
> +++ b/drivers/gpu/drm/i915/display/intel_dsi_dcs_backlight.c
> @@ -66,10 +66,9 @@ static void dcs_set_backlight(const struct drm_connector_state *conn_state, u32
>  {
>  	struct intel_dsi *intel_dsi = enc_to_intel_dsi(to_intel_encoder(conn_state->best_encoder));
>  	struct mipi_dsi_device *dsi_device;
> -	u8 data = level;
> +	__be16 data = cpu_to_be16(level);

Just discussed this with Vandita. Both the set and get brightness need
to be adjusted, and the read/write size (one or two bytes) has to depend
on the precision. From MIPI DCS spec:

	Note: It is up to display manufacturer to determine the
	implementation of this register and background logic. Only one
	parameter shall be sent for devices that support 8-bit
	brightness levels. Two parameters shall be sent for devices that
	support between 9-bit and 16-bit brightness levels.

BR,
Jani.


>  	enum port port;
>  
> -	/* FIXME: Need to take care of 16 bit brightness level */
>  	for_each_dsi_port(port, intel_dsi->dcs_backlight_ports) {
>  		dsi_device = intel_dsi->dsi_hosts[port]->device;
>  		mipi_dsi_dcs_write(dsi_device, MIPI_DCS_SET_DISPLAY_BRIGHTNESS,

-- 
Jani Nikula, Intel Open Source Graphics Center