[Intel-gfx] [PATCH 4/5] drm/i915: Move HDMI vswing programming to the right place

[Imre Deak]

On Thu, Jan 28, 2021 at 05:59:47PM +0200, Ville Syrjala wrote:
> From: Ville Syrjälä <ville.syrjala at linux.intel.com>
> 
> The documented programming sequence indicates the correct point
> for the vswing programming is just before we enable the DDI.
> Make it so.
> 
> Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
> ---
>  drivers/gpu/drm/i915/display/intel_ddi.c | 30 ++++++++++++------------
>  1 file changed, 15 insertions(+), 15 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/display/intel_ddi.c b/drivers/gpu/drm/i915/display/intel_ddi.c
> index 8fbeb8c24efb..efcdf5499903 100644
> --- a/drivers/gpu/drm/i915/display/intel_ddi.c
> +++ b/drivers/gpu/drm/i915/display/intel_ddi.c
> @@ -3893,7 +3893,6 @@ static void intel_ddi_pre_enable_hdmi(struct intel_atomic_state *state,
>  	struct intel_digital_port *dig_port = enc_to_dig_port(encoder);
>  	struct intel_hdmi *intel_hdmi = &dig_port->hdmi;
>  	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> -	int level = intel_ddi_hdmi_level(encoder, crtc_state);
>  
>  	intel_dp_dual_mode_set_tmds_output(intel_hdmi, true);
>  	intel_ddi_clk_select(encoder, crtc_state);
> @@ -3904,20 +3903,6 @@ static void intel_ddi_pre_enable_hdmi(struct intel_atomic_state *state,
>  
>  	icl_program_mg_dp_mode(dig_port, crtc_state);
>  
> -	if (INTEL_GEN(dev_priv) >= 12)
> -		tgl_ddi_vswing_sequence(encoder, crtc_state, level);
> -	else if (INTEL_GEN(dev_priv) == 11)
> -		icl_ddi_vswing_sequence(encoder, crtc_state, level);
> -	else if (IS_CANNONLAKE(dev_priv))
> -		cnl_ddi_vswing_sequence(encoder, crtc_state, level);
> -	else if (IS_GEN9_LP(dev_priv))
> -		bxt_ddi_vswing_sequence(encoder, crtc_state, level);
> -	else
> -		intel_prepare_hdmi_ddi_buffers(encoder, level);
> -
> -	if (IS_GEN9_BC(dev_priv))
> -		skl_ddi_set_iboost(encoder, crtc_state, level);
> -
>  	intel_ddi_enable_pipe_clock(encoder, crtc_state);
>  
>  	dig_port->set_infoframes(encoder,
> @@ -4293,6 +4278,7 @@ static void intel_enable_ddi_hdmi(struct intel_atomic_state *state,
>  	struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
>  	struct intel_digital_port *dig_port = enc_to_dig_port(encoder);
>  	struct drm_connector *connector = conn_state->connector;
> +	int level = intel_ddi_hdmi_level(encoder, crtc_state);
>  	enum port port = encoder->port;
>  
>  	if (!intel_hdmi_handle_sink_scrambling(encoder, connector,
> @@ -4302,6 +4288,20 @@ static void intel_enable_ddi_hdmi(struct intel_atomic_state *state,
>  			    "[CONNECTOR:%d:%s] Failed to configure sink scrambling/TMDS bit clock ratio\n",
>  			    connector->base.id, connector->name);
>  
> +	if (INTEL_GEN(dev_priv) >= 12)
> +		tgl_ddi_vswing_sequence(encoder, crtc_state, level);
> +	else if (INTEL_GEN(dev_priv) == 11)
> +		icl_ddi_vswing_sequence(encoder, crtc_state, level);
> +	else if (IS_CANNONLAKE(dev_priv))
> +		cnl_ddi_vswing_sequence(encoder, crtc_state, level);
> +	else if (IS_GEN9_LP(dev_priv))
> +		bxt_ddi_vswing_sequence(encoder, crtc_state, level);
> +	else
> +		intel_prepare_hdmi_ddi_buffers(encoder, level);

It's not specified where to do this on HSW, but I assume it matches BDW:
Reviewed-by: Imre Deak <imre.deak at intel.com>

> +
> +	if (IS_GEN9_BC(dev_priv))
> +		skl_ddi_set_iboost(encoder, crtc_state, level);
> +
>  	/* Display WA #1143: skl,kbl,cfl */
>  	if (IS_GEN9_BC(dev_priv)) {
>  		/*
> -- 
> 2.26.2
> 
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx