[Intel-gfx] [PATCH] drm/i915/display: Enable second VDSC engine for higher moderates

[Kulkarni, Vandita]

> -----Original Message-----
> From: Lisovskiy, Stanislav <stanislav.lisovskiy at intel.com>
> Sent: Tuesday, September 14, 2021 12:49 PM
> To: Kulkarni, Vandita <vandita.kulkarni at intel.com>
> Cc: intel-gfx at lists.freedesktop.org; Nikula, Jani <jani.nikula at intel.com>;
> Navare, Manasi D <manasi.d.navare at intel.com>
> Subject: Re: [Intel-gfx] [PATCH] drm/i915/display: Enable second VDSC
> engine for higher moderates
> 
> On Mon, Sep 13, 2021 at 08:09:23PM +0530, Vandita Kulkarni wrote:
> > Each VDSC operates with 1ppc throughput, hence enable the second VDSC
> > engine when moderate is higher that the current cdclk.
> >
> > Signed-off-by: Vandita Kulkarni <vandita.kulkarni at intel.com>
> > ---
> >  drivers/gpu/drm/i915/display/intel_dp.c | 12 ++++++++++--
> >  1 file changed, 10 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
> > b/drivers/gpu/drm/i915/display/intel_dp.c
> > index 161c33b2c869..55878f65f724 100644
> > --- a/drivers/gpu/drm/i915/display/intel_dp.c
> > +++ b/drivers/gpu/drm/i915/display/intel_dp.c
> > @@ -70,6 +70,7 @@
> >  #include "intel_tc.h"
> >  #include "intel_vdsc.h"
> >  #include "intel_vrr.h"
> > +#include "intel_cdclk.h"
> >
> >  #define DP_DPRX_ESI_LEN 14
> >
> > @@ -1291,10 +1292,13 @@ static int intel_dp_dsc_compute_config(struct
> intel_dp *intel_dp,
> >  				       struct drm_connector_state *conn_state,
> >  				       struct link_config_limits *limits)  {
> > +	struct intel_cdclk_state *cdclk_state;
> >  	struct intel_digital_port *dig_port = dp_to_dig_port(intel_dp);
> >  	struct drm_i915_private *dev_priv = to_i915(dig_port-
> >base.base.dev);
> >  	const struct drm_display_mode *adjusted_mode =
> >  		&pipe_config->hw.adjusted_mode;
> > +	struct intel_atomic_state *state =
> > +				to_intel_atomic_state(pipe_config-
> >uapi.state);
> >  	int pipe_bpp;
> >  	int ret;
> >
> > @@ -1373,12 +1377,16 @@ static int intel_dp_dsc_compute_config(struct
> intel_dp *intel_dp,
> >  		}
> >  	}
> >
> > +	cdclk_state = intel_atomic_get_cdclk_state(state);
> > +	if (IS_ERR(cdclk_state))
> > +		return PTR_ERR(cdclk_state);
> > +
> >  	/*
> >  	 * VDSC engine operates at 1 Pixel per clock, so if peak pixel rate
> > -	 * is greater than the maximum Cdclock and if slice count is even
> > +	 * is greater than the current Cdclock and if slice count is even
> >  	 * then we need to use 2 VDSC instances.
> >  	 */
> > -	if (adjusted_mode->crtc_clock > dev_priv->max_cdclk_freq ||
> > +	if (adjusted_mode->crtc_clock > cdclk_state->actual.cdclk ||
> 
> So in the end, we didn't have to bump CDCLK up to get rid of that?

The solution that could fix the underruns was either of these:  set max cdclk that can drive this or enable the second dsc engine if slice count  > 2  to achieve 2ppc.

> 
> Anyways, checked with BSpec 49259, seems to make sense, was no point in
> comparing to max CDCLK, which is not even currently used.
> 
> Reviewed-by: Stanislav Lisovskiy <stanislav.lisovskiy at intel.com>
> 
> >  	    pipe_config->bigjoiner) {
> >  		if (pipe_config->dsc.slice_count < 2) {
> >  			drm_dbg_kms(&dev_priv->drm,
> > --
> > 2.32.0
> >