[Intel-gfx] [PATCH] drm: Fix all occurences of the "the the" typo

[Bo Liu]

There are double "the" in messages in file drm_dp_helper.c,
i915_irq.c and panel-novatek-nt35510.c, fix it.

Signed-off-by: Bo Liu <liubo03 at inspur.com>
---
 drivers/gpu/drm/display/drm_dp_helper.c       | 2 +-
 drivers/gpu/drm/i915/i915_irq.c               | 2 +-
 drivers/gpu/drm/panel/panel-novatek-nt35510.c | 2 +-
 3 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/display/drm_dp_helper.c b/drivers/gpu/drm/display/drm_dp_helper.c
index e5bab236b3ae..32b295003f49 100644
--- a/drivers/gpu/drm/display/drm_dp_helper.c
+++ b/drivers/gpu/drm/display/drm_dp_helper.c
@@ -1597,7 +1597,7 @@ static int drm_dp_aux_reply_duration(const struct drm_dp_aux_msg *msg)
 
 /*
  * Calculate the length of the i2c transfer in usec, assuming
- * the i2c bus speed is as specified. Gives the the "worst"
+ * the i2c bus speed is as specified. Gives the "worst"
  * case estimate, ie. successful while as long as possible.
  * Doesn't account the "MOT" bit, and instead assumes each
  * message includes a START, ADDRESS and STOP. Neither does it
diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
index 73cebc6aa650..783a6ca41a61 100644
--- a/drivers/gpu/drm/i915/i915_irq.c
+++ b/drivers/gpu/drm/i915/i915_irq.c
@@ -65,7 +65,7 @@
 
 /*
  * Interrupt statistic for PMU. Increments the counter only if the
- * interrupt originated from the the GPU so interrupts from a device which
+ * interrupt originated from the GPU so interrupts from a device which
  * shares the interrupt line are not accounted.
  */
 static inline void pmu_irq_stats(struct drm_i915_private *i915,
diff --git a/drivers/gpu/drm/panel/panel-novatek-nt35510.c b/drivers/gpu/drm/panel/panel-novatek-nt35510.c
index 40ea41b0a5dd..4085822f619a 100644
--- a/drivers/gpu/drm/panel/panel-novatek-nt35510.c
+++ b/drivers/gpu/drm/panel/panel-novatek-nt35510.c
@@ -231,7 +231,7 @@ struct nt35510_config {
 	 * bits 0..2 in the lower nibble controls HCK, the booster clock
 	 * frequency, the values are the same as for PCK in @bt1ctr.
 	 * bits 4..5 in the upper nibble controls BTH, the boosting
-	 * amplification for the the step-up circuit.
+	 * amplification for the step-up circuit.
 	 * 0 = AVDD + VDDB
 	 * 1 = AVDD - AVEE
 	 * 2 = AVDD - AVEE + VDDB
-- 
2.27.0