[Intel-gfx] [PATCH v4 11/11] drm/i915/mtl: Do not update GV point, mask value

[Balasubramani Vivekanandan]

On 01.09.2022 23:03, Radhakrishna Sripada wrote:
> Display 14 and future platforms do not directly communicate to Pcode
> via mailbox the SAGV bandwidth information. PM Demand registers are
> used to communicate display power requirements to the PUnit which would
> include GV point and mask value.
> 
> Skip programming GV point and mask values through legacy pcode mailbox
> interface.

I agree to Matt's suggestion in v2 of this patch series, to move this
patch to the future series where we would introduce the new pm_demand
interface. It would make more sense there.

> 
> Bspec: 64636
> Cc: Matt Roper <matthew.d.roper at intel.com>
> Original Author: Caz Yokoyama
> Signed-off-by: Radhakrishna Sripada <radhakrishna.sripada at intel.com>
> ---
>  drivers/gpu/drm/i915/intel_pm.c | 18 ++++++++++++++++++
>  1 file changed, 18 insertions(+)
> 
> diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
> index b19a1ecb010e..69efd613bbde 100644
> --- a/drivers/gpu/drm/i915/intel_pm.c
> +++ b/drivers/gpu/drm/i915/intel_pm.c
> @@ -3923,6 +3923,14 @@ void intel_sagv_pre_plane_update(struct intel_atomic_state *state)
>  {
>  	struct drm_i915_private *i915 = to_i915(state->base.dev);
>  
> +	/*
> +	 * No need to update mask value/restrict because
> +	 * "Pcode only wants to use GV bandwidth value, not the mask value."
> +	 * for DISPLAY_VER() >= 14.
> +	 */
> +	if (DISPLAY_VER(i915) >= 14)
> +		return;
> +
My suggestion would be to remove the DISPLAY version check here and do
it at the place where this function is invoked from. So for versions
<14, intel_sagv_pre_plane_update can be called and for higher we need to
implement the new pm_demand interface.

>  	/*
>  	 * Just return if we can't control SAGV or don't have it.
>  	 * This is different from situation when we have SAGV but just can't
> @@ -3943,6 +3951,16 @@ void intel_sagv_post_plane_update(struct intel_atomic_state *state)
>  {
>  	struct drm_i915_private *i915 = to_i915(state->base.dev);
>  
> +	/*
> +	 * No need to update mask value/restrict because
> +	 * "Pcode only wants to use GV bandwidth value, not the mask value."
> +	 * for DISPLAY_VER() >= 14.
> +	 *
> +	 * GV bandwidth will be set by intel_pmdemand_post_plane_update()
> +	 */
> +	if (DISPLAY_VER(i915) >= 14)
> +		return;
ditto
> +
>  	/*
>  	 * Just return if we can't control SAGV or don't have it.
>  	 * This is different from situation when we have SAGV but just can't

Regards,
Bala
> -- 
> 2.34.1
>