[Intel-gfx] [PATCH] drm/i915/hotplug: Reduce SHPD_FILTER to 250us

Suraj Kandpal suraj.kandpal at intel.com
Thu Jul 20 10:46:24 UTC 2023


On TGP, the RTC (always running) was reduced from 3MHz to 32KHz.
As a result of this change, when HPD active going low pulse or HPD IRQ
is presented and the refclk (19.2MHz) is not toggling already toggling,
there is a 60 to 90us synchronization delay which effectively reduces
the duration of the IRQ pulse to less than the programmed 500us filter
value and the hot plug interrupt is NOT registered.
Solution was to Reduce SHPD_FILTER to 250us for ADL and above.
This solution was derived when the below patch was floated.
[1]https://patchwork.freedesktop.org/patch/532187
and after some internal discussion Ville's suggestion made sense.

Bspec: 68970

Cc: Uma Shankar <uma.shankar at intel.com>
Cc: Ville Syrjala <ville.syrjala at linux.intel.com>
Suggested-by: Ville Syrjala <ville.syrjala at linux.intel.com>
Signed-off-by: Suraj Kandpal <suraj.kandpal at intel.com>
Reviewed-by: Uma Shankar <uma.shankar at intel.com>
---
 drivers/gpu/drm/i915/display/intel_hotplug_irq.c | 4 +++-
 drivers/gpu/drm/i915/i915_reg.h                  | 1 +
 2 files changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/i915/display/intel_hotplug_irq.c b/drivers/gpu/drm/i915/display/intel_hotplug_irq.c
index f95fa793fabb..95a7ea94f417 100644
--- a/drivers/gpu/drm/i915/display/intel_hotplug_irq.c
+++ b/drivers/gpu/drm/i915/display/intel_hotplug_irq.c
@@ -842,6 +842,8 @@ static void icp_hpd_irq_setup(struct drm_i915_private *dev_priv)
 
 	if (INTEL_PCH_TYPE(dev_priv) <= PCH_TGP)
 		intel_uncore_write(&dev_priv->uncore, SHPD_FILTER_CNT, SHPD_FILTER_CNT_500_ADJ);
+	else
+		intel_uncore_write(&dev_priv->uncore, SHPD_FILTER_CNT, SHPD_FILTER_CNT_250);
 
 	ibx_display_interrupt_update(dev_priv, hotplug_irqs, enabled_irqs);
 
@@ -1049,7 +1051,7 @@ static void mtp_hpd_irq_setup(struct drm_i915_private *i915)
 	enabled_irqs = intel_hpd_enabled_irqs(i915, i915->display.hotplug.pch_hpd);
 	hotplug_irqs = intel_hpd_hotplug_irqs(i915, i915->display.hotplug.pch_hpd);
 
-	intel_de_write(i915, SHPD_FILTER_CNT, SHPD_FILTER_CNT_500_ADJ);
+	intel_de_write(i915, SHPD_FILTER_CNT, SHPD_FILTER_CNT_250);
 
 	mtp_hpd_invert(i915);
 	ibx_display_interrupt_update(i915, hotplug_irqs, enabled_irqs);
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index dcf64e32cd54..aefad14ab27a 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -4939,6 +4939,7 @@
 
 #define SHPD_FILTER_CNT				_MMIO(0xc4038)
 #define   SHPD_FILTER_CNT_500_ADJ		0x001D9
+#define   SHPD_FILTER_CNT_250			0x000F8
 
 #define _PCH_DPLL_A              0xc6014
 #define _PCH_DPLL_B              0xc6018
-- 
2.25.1



More information about the Intel-gfx mailing list