[Intel-gfx] [PATCH 19/29] drm/i915/dp: Disable FEC ready flag in the sink
Imre Deak
imre.deak at intel.com
Tue Oct 24 01:09:15 UTC 2023
Disable the FEC ready flag in the sink during a disabling modeset.
Signed-off-by: Imre Deak <imre.deak at intel.com>
---
drivers/gpu/drm/i915/display/intel_ddi.c | 21 +++++++++++++--------
1 file changed, 13 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/i915/display/intel_ddi.c b/drivers/gpu/drm/i915/display/intel_ddi.c
index 6f9d0f2ff3d9a..99d96762fa29c 100644
--- a/drivers/gpu/drm/i915/display/intel_ddi.c
+++ b/drivers/gpu/drm/i915/display/intel_ddi.c
@@ -2211,18 +2211,21 @@ static void intel_dp_sink_set_msa_timing_par_ignore_state(struct intel_dp *intel
}
static void intel_dp_sink_set_fec_ready(struct intel_dp *intel_dp,
- const struct intel_crtc_state *crtc_state)
+ const struct intel_crtc_state *crtc_state,
+ bool enable)
{
struct drm_i915_private *i915 = dp_to_i915(intel_dp);
if (!crtc_state->fec_enable)
return;
- if (drm_dp_dpcd_writeb(&intel_dp->aux, DP_FEC_CONFIGURATION, DP_FEC_READY) <= 0)
- drm_dbg_kms(&i915->drm,
- "Failed to set FEC_READY in the sink\n");
+ if (drm_dp_dpcd_writeb(&intel_dp->aux, DP_FEC_CONFIGURATION,
+ enable ? DP_FEC_READY : 0) <= 0)
+ drm_dbg_kms(&i915->drm, "Failed to set FEC_READY to %s in the sink\n",
+ enable ? "enabled" : "disabled");
- if (drm_dp_dpcd_writeb(&intel_dp->aux, DP_FEC_STATUS,
+ if (enable &&
+ drm_dp_dpcd_writeb(&intel_dp->aux, DP_FEC_STATUS,
DP_FEC_DECODE_EN_DETECTED | DP_FEC_DECODE_DIS_DETECTED) <= 0)
drm_dbg_kms(&i915->drm, "Failed to clear FEC detected flags\n");
}
@@ -2541,7 +2544,7 @@ static void mtl_ddi_pre_enable_dp(struct intel_atomic_state *state,
* in the FEC_CONFIGURATION register to 1 before initiating link
* training
*/
- intel_dp_sink_set_fec_ready(intel_dp, crtc_state);
+ intel_dp_sink_set_fec_ready(intel_dp, crtc_state, true);
intel_dp_check_frl_training(intel_dp);
intel_dp_pcon_dsc_configure(intel_dp, crtc_state);
@@ -2692,7 +2695,7 @@ static void tgl_ddi_pre_enable_dp(struct intel_atomic_state *state,
* in the FEC_CONFIGURATION register to 1 before initiating link
* training
*/
- intel_dp_sink_set_fec_ready(intel_dp, crtc_state);
+ intel_dp_sink_set_fec_ready(intel_dp, crtc_state, true);
intel_dp_check_frl_training(intel_dp);
intel_dp_pcon_dsc_configure(intel_dp, crtc_state);
@@ -2768,7 +2771,7 @@ static void hsw_ddi_pre_enable_dp(struct intel_atomic_state *state,
intel_dp_configure_protocol_converter(intel_dp, crtc_state);
intel_dp_sink_set_decompression_state(intel_dp, crtc_state,
true);
- intel_dp_sink_set_fec_ready(intel_dp, crtc_state);
+ intel_dp_sink_set_fec_ready(intel_dp, crtc_state, true);
intel_dp_start_link_train(intel_dp, crtc_state);
if ((port != PORT_A || DISPLAY_VER(dev_priv) >= 9) &&
!is_trans_port_sync_mode(crtc_state))
@@ -2997,6 +3000,8 @@ static void intel_ddi_post_disable_dp(struct intel_atomic_state *state,
intel_disable_ddi_buf(encoder, old_crtc_state);
+ intel_dp_sink_set_fec_ready(intel_dp, old_crtc_state, false);
+
/*
* From TGL spec: "If single stream or multi-stream master transcoder:
* Configure Transcoder Clock select to direct no clock to the
--
2.39.2
More information about the Intel-gfx
mailing list