[Intel-gfx] [PATCH 4/4] drm/i915/dp_mst: Tune down error message during payload addition

[Imre Deak]

If a sink is removed in the middle of payload addition
drm_dp_add_payload_part1() will fail as expected, either not finding the
payload's MST port or failing the payload-add AUX transaction.

Based on the above tune the error message down to a debug messge.

Cc: Lyude Paul <lyude at redhat.com>
Signed-off-by: Imre Deak <imre.deak at intel.com>
---
 drivers/gpu/drm/i915/display/intel_dp_mst.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/display/intel_dp_mst.c b/drivers/gpu/drm/i915/display/intel_dp_mst.c
index 1c7f0b6afe475..ff3accebf0a89 100644
--- a/drivers/gpu/drm/i915/display/intel_dp_mst.c
+++ b/drivers/gpu/drm/i915/display/intel_dp_mst.c
@@ -726,8 +726,8 @@ static void intel_mst_pre_enable_dp(struct intel_atomic_state *state,
 	ret = drm_dp_add_payload_part1(&intel_dp->mst_mgr, mst_state,
 				       drm_atomic_get_mst_payload_state(mst_state, connector->port));
 	if (ret < 0)
-		drm_err(&dev_priv->drm, "Failed to create MST payload for %s: %d\n",
-			connector->base.name, ret);
+		drm_dbg_kms(&dev_priv->drm, "Failed to create MST payload for %s: %d\n",
+			    connector->base.name, ret);
 
 	/*
 	 * Before Gen 12 this is not done as part of
-- 
2.37.2