[PATCH v2 1/4] drm/amd/display: Remove unnecessary SIGNAL_TYPE_HDMI_TYPE_A check

[Andri Yngvason]

From: Werner Sembach <wse at tuxedocomputers.com>

Remove unnecessary SIGNAL_TYPE_HDMI_TYPE_A check that was performed in the
drm_mode_is_420_only() case, but not in the drm_mode_is_420_also() &&
force_yuv420_output case.

Without further knowledge if YCbCr 4:2:0 is supported outside of HDMI,
there is no reason to use RGB when the display
reports drm_mode_is_420_only() even on a non HDMI connection.

This patch also moves both checks in the same if-case. This  eliminates an
extra else-if-case.

Signed-off-by: Werner Sembach <wse at tuxedocomputers.com>
Signed-off-by: Andri Yngvason <andri at yngvason.is>
Tested-by: Andri Yngvason <andri at yngvason.is>
---
 drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c | 6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
index f6575d7dee971..cc4d1f7f97b98 100644
--- a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
+++ b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
@@ -5575,11 +5575,7 @@ static void fill_stream_properties_from_drm_display_mode(
 	timing_out->v_border_bottom = 0;
 	/* TODO: un-hardcode */
 	if (drm_mode_is_420_only(info, mode_in)
-			&& stream->signal == SIGNAL_TYPE_HDMI_TYPE_A)
-		timing_out->pixel_encoding = PIXEL_ENCODING_YCBCR420;
-	else if (drm_mode_is_420_also(info, mode_in)
-			&& aconnector
-			&& aconnector->force_yuv420_output)
+			|| (drm_mode_is_420_also(info, mode_in) && aconnector->force_yuv420_output))
 		timing_out->pixel_encoding = PIXEL_ENCODING_YCBCR420;
 	else if ((connector->display_info.color_formats & DRM_COLOR_FORMAT_YCBCR444)
 			&& stream->signal == SIGNAL_TYPE_HDMI_TYPE_A)
-- 
2.43.0