[PATCH 06/14] drm/i915/dp: Send only a single modeset-retry uevent for a commit

Murthy, Arun R arun.r.murthy at intel.com
Thu Jul 25 03:16:03 UTC 2024


> -----Original Message-----
> From: Deak, Imre <imre.deak at intel.com>
> Sent: Wednesday, July 24, 2024 4:46 PM
> To: Murthy, Arun R <arun.r.murthy at intel.com>
> Cc: intel-gfx at lists.freedesktop.org
> Subject: Re: [PATCH 06/14] drm/i915/dp: Send only a single modeset-retry
> uevent for a commit
> 
> On Wed, Jul 24, 2024 at 07:29:33AM +0300, Murthy, Arun R wrote:
> >
> > > -----Original Message-----
> > > From: Intel-gfx <intel-gfx-bounces at lists.freedesktop.org> On Behalf
> > > Of Imre Deak
> > > Sent: Monday, July 22, 2024 10:25 PM
> > > To: intel-gfx at lists.freedesktop.org
> > > Subject: [PATCH 06/14] drm/i915/dp: Send only a single modeset-retry
> > > uevent for a commit
> > >
> > > There are multiple failure cases a modeset-retry uevent can be sent
> > > for a link (TBT tunnel BW allocation failure, unrecoverable link
> > > training failure), a follow- up patch adding the handling for a new
> > > case where the DP MST payload allocation fails. The uevent is the
> > > same in all cases, sent to all the connectors on the link, so in
> > > case of multiple failures there is no point in sending a separate
> > > uevent for each failure; prevent this, sending only a single modeset-retry
> uevent for a commit.
> > >
> > Is an exit condition required with some 'x' retry so that this retry
> > doesn't end up in an infinite loop.  For link training failure the
> > link rate/lane count is reduced and when it reaches the least can
> > exit, but for BW allocation failures/payload failure this may not be
> > the case.
> 
> This is an error condition the driver reports (asynchronously) if a modeset
> request by userspace/client failed. It would be incorrect not to report this error,
> leaving the output in a blank, enabled state.
> 
> I think that userspace/client should handle such failures - in the above case a
> buggy sink - by disabling the output.
> 
If user space doesn't then I think we end up in an infinite loop in KMD. So would it make some sense to have some exit condition in KMD.

Thanks and Regards,
Arun R Murthy
--------------------
> > Thanks and Regards,
> > Arun R Murthy
> > --------------------
> > > Signed-off-by: Imre Deak <imre.deak at intel.com>
> > > ---
> > >  drivers/gpu/drm/i915/display/intel_display_types.h | 1 +
> > >  drivers/gpu/drm/i915/display/intel_dp.c            | 6 ++++++
> > >  2 files changed, 7 insertions(+)
> > >
> > > diff --git a/drivers/gpu/drm/i915/display/intel_display_types.h
> > > b/drivers/gpu/drm/i915/display/intel_display_types.h
> > > index a9d2acdc51a4a..3501125c55158 100644
> > > --- a/drivers/gpu/drm/i915/display/intel_display_types.h
> > > +++ b/drivers/gpu/drm/i915/display/intel_display_types.h
> > > @@ -1754,6 +1754,7 @@ struct intel_dp {
> > >       u8 lane_count;
> > >       u8 sink_count;
> > >       bool link_trained;
> > > +     bool needs_modeset_retry;
> > >       bool use_max_params;
> > >       u8 dpcd[DP_RECEIVER_CAP_SIZE];
> > >       u8 psr_dpcd[EDP_PSR_RECEIVER_CAP_SIZE];
> > > diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
> > > b/drivers/gpu/drm/i915/display/intel_dp.c
> > > index 421e970b3c180..0882dddd97206 100644
> > > --- a/drivers/gpu/drm/i915/display/intel_dp.c
> > > +++ b/drivers/gpu/drm/i915/display/intel_dp.c
> > > @@ -2876,6 +2876,11 @@ intel_dp_queue_modeset_retry_for_link(struct
> > > intel_atomic_state *state,
> > >       struct intel_dp *intel_dp = enc_to_intel_dp(encoder);
> > >       int i;
> > >
> > > +     if (intel_dp->needs_modeset_retry)
> > > +             return;
> > > +
> > > +     intel_dp->needs_modeset_retry = true;
> > > +
> > >       if (!intel_crtc_has_type(crtc_state, INTEL_OUTPUT_DP_MST)) {
> > >               intel_dp_queue_modeset_retry_work(intel_dp-
> > > >attached_connector);
> > >
> > > @@ -3009,6 +3014,7 @@ void intel_dp_set_link_params(struct intel_dp
> > > *intel_dp,  {
> > >       memset(intel_dp->train_set, 0, sizeof(intel_dp->train_set));
> > >       intel_dp->link_trained = false;
> > > +     intel_dp->needs_modeset_retry = false;
> > >       intel_dp->link_rate = link_rate;
> > >       intel_dp->lane_count = lane_count;  }
> > > --
> > > 2.44.2
> >


More information about the Intel-gfx mailing list