Huawei E3276 problem

[Tommy Cheng]

Just sending AT^NDISDUP=1,1,"yourapn" to Huawei E3276 through serial port and then using dhcp cleint to ip address.

I just simply add the following lines to cdc_ncm.c for my tests.
it's a ugly patch.

{ USB_INTERFACE_INFO(0xff,
0x02, 0x16),
.driver_info = (unsigned long)&cdc_ncm_info,
},






----- Original Message -----
From: Bjørn Mork <bjorn at mork.no>
To: Tommy Cheng <tommy7765 at yahoo.com>
Cc: Olof Ermis <olof.ermis at gmail.com>; "libqmi-devel at lists.freedesktop.org" <libqmi-devel at lists.freedesktop.org>; Thomas Schäfer <tschaefer at t-online.de>
Sent: Friday, November 9, 2012 3:30 PM
Subject: Re: Huawei E3276 problem

Tommy Cheng <tommy7765 at yahoo.com> writes:

> Huawei E3276 does not have QMI interface so that cdc-wdm + qmi_wwan
> is not working on this device.  I tried to use Huawei hw_cdc_driver and 
> cdc_ncm driver on Huawei E3276.  Both drivers are working good.

How do you manage (configure, connect, disconnect etc) the device?  By
AT commands on the serial port?

Did you patch the cdc_ncm driver to support this?  Would you mind
signing off and sending that patch upstream?



Bjørn
_______________________________________________
libqmi-devel mailing list
libqmi-devel at lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/libqmi-devel