Huawei E3276 problem

[Tommy Cheng]

no, you don't need hw_cdc_driver from Huawei.


----- Original Message -----
From: Olof Ermis <olof.ermis at gmail.com>
To: Tommy Cheng <tommy7765 at yahoo.com>
Cc: Bjørn Mork <bjorn at mork.no>; "libqmi-devel at lists.freedesktop.org" <libqmi-devel at lists.freedesktop.org>; Thomas Schäfer <tschaefer at t-online.de>
Sent: Friday, November 9, 2012 7:50 PM
Subject: Re: Huawei E3276 problem

And to do this, did I need to install the Huawei drivers as well (from
the Linux Driver 4.19.07.00.tar.gz package) or I make the change below
on a standard linux dist?

/Olof

2012/11/9 Tommy Cheng <tommy7765 at yahoo.com>:
> Just sending AT^NDISDUP=1,1,"yourapn" to Huawei E3276 through serial port and then using dhcp cleint to ip address.
>
> I just simply add the following lines to cdc_ncm.c for my tests.
> it's a ugly patch.
>
> { USB_INTERFACE_INFO(0xff,
> 0x02, 0x16),
> .driver_info = (unsigned long)&cdc_ncm_info,
> },
>
>
>
>
>
>
> ----- Original Message -----
> From: Bjørn Mork <bjorn at mork.no>
> To: Tommy Cheng <tommy7765 at yahoo.com>
> Cc: Olof Ermis <olof.ermis at gmail.com>; "libqmi-devel at lists.freedesktop.org" <libqmi-devel at lists.freedesktop.org>; Thomas Schäfer <tschaefer at t-online.de>
> Sent: Friday, November 9, 2012 3:30 PM
> Subject: Re: Huawei E3276 problem
>
> Tommy Cheng <tommy7765 at yahoo.com> writes:
>
>> Huawei E3276 does not have QMI interface so that cdc-wdm + qmi_wwan
>> is not working on this device.  I tried to use Huawei hw_cdc_driver and
>> cdc_ncm driver on Huawei E3276.  Both drivers are working good.
>
> How do you manage (configure, connect, disconnect etc) the device?  By
> AT commands on the serial port?
>
> Did you patch the cdc_ncm driver to support this?  Would you mind
> signing off and sending that patch upstream?
>
>
>
> Bjørn
> _______________________________________________
> libqmi-devel mailing list
> libqmi-devel at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/libqmi-devel
>