Telit LE910-NVG

[Daniele Palmas]

Hi Randy,

2016-02-06 5:55 GMT+01:00 Randy Yates <yates at digitalsignallabs.com>:
> Bjørn Mork <bjorn at mork.no> writes:
>
>> Randy Yates <yates at digitalsignallabs.com> writes:
>>
>>> Bjorn, first, thank you very much for your help. I respond
>>> to you below. Also note that my mail server went down
>>> just after I posted this message to the list. It is now
>>> back up.
>>
>> Yes, I noticed that.  Hoped you would see the mail in the list archive.
>>
>> Anyway, all the output looks good.  Still interesting to see the AT cfg
>> output.
>
> I get an error.
>
>>> [   46.178615] qmi_wwan 1-1:1.2: cdc-wdm0: USB WDM device
>>> [   46.200385] qmi_wwan 1-1:1.2 wwan0: register 'qmi_wwan' at usb-musb-hdrc.1.auto-1, WWAN/QMI device, 0e:41:a8:34:00:f5
>>
>> But in any case:  This shows that you do have the /dev/cdc-wdm0 and
>> wwan0 devices which should allow you to test QMI.
>
> wwan0? That sounds an awful lot like a network interface name, but
> ifconfig only shows the usual "lo" and "eth0" names.
>

Maybe a stupid question, but did you try

ifconfig -a

?

Regards,
Daniele

> --
> Randy Yates, DSP/Embedded Firmware Developer
> Digital Signal Labs
> http://www.digitalsignallabs.com
> _______________________________________________
> libqmi-devel mailing list
> libqmi-devel at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/libqmi-devel