Problems starting the network

[Erik Kazandjian]

Thanks Aleksander, after setting the autoconnect to disabled I could 
start the network again and could obtain an IP address with dhcp

Regards

Erik


On 05/07/2018 05:54 PM, Aleksander Morgado wrote:
>> Starting network with 'qmicli -d /dev/cdc-wdm0
>> --wds-start-network=apn='internet'  --client-no-release-cid '...
>> error: couldn't start network: QMI protocol error (26): 'NoEffect'
>> Saving state at /tmp/qmi-network-state-cdc-wdm0... (CID: 35)
>> error: network start failed, no packet data handle
> That NoEffect error means the context is already connected, so that's
> why you get a packet data handle.
> As it is already connected, it may be because it's set to autoconnect
> (check with qmicli --wds-get-autoconnect-settings), and you can just
> gather current IP settings (qmicli --wds-get-current-settings) to see
> what needs to be configured in the network interface.
>