<div dir="ltr">Hi all,<div><br></div><div>My device seems to support LTE-FDD bands 1, 3, 5 but the system selection preference is not able to show them:</div><div><br></div><div>pi@okamoto:~ $ qmicli -d /dev/cdc-wdm0 --dms-get-band-capabilities<br>[/dev/cdc-wdm0] Device band capabilities retrieved:<br>       Bands: 'gsm-dcs-1800, gsm-900-extended, gsm-900-primary, wcdma-2100, wcdma-900'<br>       LTE bands: '1, 3, 8, 38, 39, 40, 41'<br><br></div><div>pi@okamoto:~ $ qmicli -d /dev/cdc-wdm0 --nas-get-system-selection-preference<br>[/dev/cdc-wdm0] Successfully got system selection preference<br>     Emergency mode: 'no'<br>  Mode preference: 'lte'<br>        Band preference: 'gsm-dcs-1800, gsm-900-extended, gsm-900-primary, wcdma-2100, wcdma-900'<br>     LTE band preference: '38, 39, 40, 41'<br> TD-SCDMA band preference: 'a, f'<br>      Roaming preference: 'any'<br>     Network selection preference: 'automatic'<br>     Service domain preference: 'cs-ps'<br>    GSM/WCDMA acquisition order preference: 'automatic'<br>   Acquisition order preference: lte, cdma-1xevdo, cdma-1x, td-scdma, umts, gsm<br></div><div><br></div><div><br></div><div>I have been doing some searching online but only found something like "qmi_message_nas_set_system_selection_preference_input_set_lte_band_preference" so I wonder if there are actually any command line options which I can use to enable those LTE-FDD bands please?</div><div><br></div><div>Thanks,</div><div>Leo</div><div><br></div><div><br></div><div><br></div></div>