[Libreoffice] Couldn't debug fdo#30550 (WAS: Build failed in sfx2 in -3-3 branch)

[Petr Mladek]

Korrawit Pruegsanusak píše v Po 20. 06. 2011 v 23:52 +0700:
> Hello Petr, Michael, *
> How do I know that libegg module is built and delivered?

You should see solver/330/unxlng?6.pro/inc/eggtray/eggtrayicon.h
The delivered files are described in libegg/prj/d.lst. They are
delivered from libegg/ to solver/

> And yes, my clone/libs-extern/libegg does exists.

if it is built, you will find there the libegg/unxlng* subdirectory

> Just for a reminder: I was trying to fix fdo#30550: wordcount without
> space counted incorrectly
> Next, I was trying to use gdb debug by following [1], but it wasn't
> success. This was my trying:
> 
> I ./autogen.sh with --enable-symbols[1], make, make dev-install, build
> debug=true in sw[2], then run swriter
> After attaching soffice.bin to gdb using
>   gdb soffice.bin $LOPID[1]
> libo writer was paused (which is normal, isn't it?)

Yes, it is normal. You need to write "continue" in gdb to make the
application runnig again.

> Notice: there're many shouts from gdb at me after attached, like
>   Reading symbol from /usr/lib/libk5crypto.so.3...(no debugging
> symbols found)...done.
>   Loaded symbols for /usr/lib/libk5crypto.so.3
> etc.

It is normal. You would need to install debug packages for these system
libraries. Well. you do not need them, if you do not want to trace the
code in this libraries. It should not be needed.

> Did I walk through a right way? And sorry if any of my questions or
> above procedure seem stupid.

Do not worry. You are on the right way :-)


Best Regards,
Petr