[Libreoffice] Couldn't debug fdo#30550 (WAS: Build failed in sfx2 in -3-3 branch)

[Petr Mladek]

Korrawit Pruegsanusak píše v St 22. 06. 2011 v 20:26 +0700:
> Hello Petr, all,
> 
> On Wed, Jun 22, 2011 at 02:19, Petr Mladek <pmladek at suse.cz> wrote:
> > Korrawit Pruegsanusak píše v Po 20. 06. 2011 v 23:52 +0700:
> >> How do I know that libegg module is built and delivered?
> >
> > You should see solver/330/unxlng?6.pro/inc/eggtray/eggtrayicon.h
> > The delivered files are described in libegg/prj/d.lst. They are
> > delivered from libegg/ to solver/
> >
> >> And yes, my clone/libs-extern/libegg does exists.
> >
> > if it is built, you will find there the libegg/unxlng* subdirectory
> 
> Thanks again :-)
> Indeed, my libegg module didn't build. There're no
> solver/.../eggtray/... nor libegg/unxlng*
> But how could this happen? (to prevent it happen again in future ...)

It is built only when the systray stuff is enabled. There must be listed
SYSTRAY_GTK in the BUILD_TYPE variable. The variable is set by the
profile  Linux*Env.Set.sh. The profile is generated by the top level
configure, ...

Note that this build dependency is defined in sfx2/prj/build.lst, see
the SYSTRAY_GTK:libegg on the first line.


Best Regards,
Petr