[Mesa-dev] [RFC PATCH 09/16] i965/gen6 blorp depth: calculate base surface width/height

[Jordan Justen]

(e3a49e1 for gen6)

This will be used in 3DSTATE_DEPTH_BUFFER in a later patch.

Signed-off-by: Jordan Justen <jordan.l.justen at intel.com>
---
 src/mesa/drivers/dri/i965/gen6_blorp.cpp | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/src/mesa/drivers/dri/i965/gen6_blorp.cpp b/src/mesa/drivers/dri/i965/gen6_blorp.cpp
index 5a55676..f14ea90 100644
--- a/src/mesa/drivers/dri/i965/gen6_blorp.cpp
+++ b/src/mesa/drivers/dri/i965/gen6_blorp.cpp
@@ -792,6 +792,7 @@ gen6_blorp_emit_depth_stencil_config(struct brw_context *brw,
    uint32_t draw_x = params->depth.x_offset;
    uint32_t draw_y = params->depth.y_offset;
    uint32_t tile_mask_x, tile_mask_y;
+   uint32_t surfwidth, surfheight;
    uint32_t surftype;
    unsigned int depth = MAX2(params->depth.mt->logical_depth0, 1);
    unsigned int min_array_element;
@@ -824,6 +825,18 @@ gen6_blorp_emit_depth_stencil_config(struct brw_context *brw,
 
    lod = params->depth.level - params->depth.mt->first_level;
 
+   if (params->hiz_op != GEN6_HIZ_OP_NONE && lod == 0) {
+      /* HIZ ops for lod 0 may set the width & height a little
+       * larger to allow the fast depth clear to fit the hardware
+       * alignment requirements. (8x4)
+       */
+      surfwidth = params->depth.width;
+      surfheight = params->depth.height;
+   } else {
+      surfwidth = params->depth.mt->logical_width0;
+      surfheight = params->depth.mt->logical_height0;
+   }
+
    /* 3DSTATE_DEPTH_BUFFER */
    {
       uint32_t tile_x = draw_x & tile_mask_x;
-- 
2.0.0.rc4