<div dir="ltr"><div><div><div>Hi!<br><br>I'm using ModemManager 1.18.6 with Quectel EG21-G modem and Twilio SuperSIM.</div><div><br>This setup works ok on multiple devices.<br>However, on a few devices, I see following situation:<br></div><ul><li style="margin-left:15px"><p>Modem registered to operator network (e.g. Vodafone UK)</p></li><li style="margin-left:15px"><p>Modem reports connected state<br></p></li><li style="margin-left:15px"><p>wwan0 interface has IPv4 address </p></li><li style="margin-left:15px"><p>Network provider sees no issues</p></li><li style="margin-left:15px"><p>in Network provider console you can see the device exchanges a few hundred kB of data every hour</p></li><li style="margin-left:15px"><p>but ping doesn’t work</p></li><li style="margin-left:15px"><p>sending data fails</p></li></ul></div>This looks strange, as if ModemManager was not aware of the data session that is setup, or Linux system not being able to use it.<br><br>The simplified flow of using the modem:<br>- enable modem<br>- wait until it auto-registers<br>- create a bearer and connect<br>- when bearer obtains IP address, configure the network interface<br><br>I attached relevant mmcli information from the device (modem, bearer) and debug level logs from 2 situations:<br>- device stable in connected state (but ping fails)<br>- modem reset - sequence of enable, register, connect -> goes into the same state where ping does not work.<br>I also attached the commands that are used for setting up the network interface when a new IP address is obtained.<br><br>What should I check, or do you know how to avoid this situation?<br></div><br clear="all"><div><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><span style="color:rgb(0,0,0);font-family:Helvetica;font-size:12px">Kind regards,</span><br style="color:rgb(0,0,0);font-family:Helvetica;font-size:12px"><span style="color:rgb(0,0,0);font-family:Helvetica;font-size:12px">Filip</span></div></div></div></div>