[Nouveau] [Bug 14060] Server fails to start with randr 1.2 and a NV20

[bugzilla-daemon at freedesktop.org]

http://bugs.freedesktop.org/show_bug.cgi?id=14060





--- Comment #3 from Mathieu Bérard <mathieu.berard at crans.org>  2008-01-13 10:18:13 PST ---
The card has 1 VGA, 1 DVI and 1 S-Video outputs.

lspci -vvv info:

01:00.0 VGA compatible controller: nVidia Corporation NV20 [GeForce3 Ti 500]
(rev a3) (prog-if 00 [VGA])
        Subsystem: Micro-Star International Co., Ltd. Unknown device 5301
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 18
        Region 0: Memory at de000000 (32-bit, non-prefetchable) [size=16M]
        Region 1: Memory at d8000000 (32-bit, prefetchable) [size=64M]
        Region 2: Memory at ddb80000 (32-bit, prefetchable) [size=512K]
        Expansion ROM at dfdf0000 [disabled] [size=64K]
        Capabilities: [60] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [44] AGP version 2.0
                Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA- ITACoh- GART64- HTrans-
64bit- FW- AGP3- Rate=x1,x2,x4
                Command: RQ=32 ArqSz=0 Cal=0 SBA- AGP+ GART64- 64bit- FW-
Rate=x4


-- 
Configure bugmail: http://bugs.freedesktop.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.