[Nouveau] GeForce 8500 GT Connectors Reversed

[Kevin Winchester]

Hi,

I have noticed that the nouveau DRM kernel driver seems to get the
connectors reversed on my GeForce 8500 GT card.  My setup looks like:

8500GT----------VGA-----------Samsung 2043W (1680x1050)
           |______DVI_______LG L1920P (1280x1024)

but as far as the kernel is concerned, the Samsung monitor gets
detected via the DVI probing:

[    0.521009] [drm:drm_helper_probe_single_connector_modes],
[CONNECTOR:15:DVI-I-1] probed modes :
[    0.521015] [drm:drm_mode_debug_printmodeline], Modeline
21:"1680x1050" 60 119000 1680 1728 1760 1840 1050 1053 1059 1080 0x48
0x9

and the LG via the VGA probing:

[    0.551267] [drm:drm_helper_probe_single_connector_modes],
[CONNECTOR:17:VGA-1] probed modes :
[    0.551272] [drm:drm_mode_debug_printmodeline], Modeline
89:"1280x1024" 60 108000 1280 1328 1440 1688 1024 1025 1028 1066 0x48
0x5

I have used my xorg.conf configuration to re-reverse the monitor
definitions to get a working system, but should some quirk be added to
handle this particular card:

01:00.0 VGA compatible controller: NVIDIA Corporation G86 [GeForce
8500 GT] (rev a1) (prog-if 00 [VGA controller])
	Subsystem: eVga.com. Corp. Device c793
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
	Latency: 0, Cache Line Size: 64 bytes
	Interrupt: pin A routed to IRQ 25
	Region 0: Memory at fd000000 (32-bit, non-prefetchable) [size=16M]
	Region 1: Memory at a0000000 (64-bit, prefetchable) [size=256M]
	Region 3: Memory at fa000000 (64-bit, non-prefetchable) [size=32M]
	Region 5: I/O ports at dc00 [size=128]
	Expansion ROM at fe7e0000 [disabled] [size=128K]
	Capabilities: [60] Power Management version 2
		Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
		Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
	Capabilities: [68] MSI: Enable- Count=1/1 Maskable- 64bit+
		Address: 0000000000000000  Data: 0000
	Capabilities: [78] Express (v1) Endpoint, MSI 00
		DevCap:	MaxPayload 128 bytes, PhantFunc 0, Latency L0s <512ns, L1 <4us
			ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset-
		DevCtl:	Report errors: Correctable- Non-Fatal- Fatal- Unsupported-
			RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
			MaxPayload 128 bytes, MaxReadReq 512 bytes
		DevSta:	CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr- TransPend-
		LnkCap:	Port #213, Speed 2.5GT/s, Width x16, ASPM L0s L1, Latency L0
<512ns, L1 <4us
			ClockPM- Surprise- LLActRep- BwNot-
		LnkCtl:	ASPM Disabled; RCB 128 bytes Disabled- Retrain- CommClk+
			ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
		LnkSta:	Speed 2.5GT/s, Width x16, TrErr- Train- SlotClk+ DLActive-
BWMgmt- ABWMgmt-
	Kernel driver in use: nouveau

Are there any other details I can provide that could help?  Even if I
had to write the patch myself and test it, that would be fine by me
with a little advice.

Thanks,
Kevin