[Nouveau] [PATCH v2 18/22] volt: add coefficients I found on my gpu

[Martin Peres]

On 21/03/16 18:16, Karol Herbst wrote:
> I am sure that those are a bit different on other GPUs, but while testing
> the error range compared to nvidia was around 100%+-3%.
>
> Without this change we are most of the time around 10% below nvidias voltage,
> so this change causes no harm and improves the situation a lot already.
>
> The remaining task for this is to figure out which of these constants are
> chip specific and from where to get the chip specific factors
>
> Signed-off-by: Karol Herbst <nouveau at karolherbst.de>

Instead of landing these coefficients like that, I would really like if 
you could dump pfuse and check if you find these coefficients there. 
What could be done also is to re-do the work you did to find out those 
coefficients on a GPU where your coefficients are not really good and 
find out what values would have needed and then compare pfuse with the 
original card.

If this is to be considered a long task, then I am OK landing those 
coefficients, but I would really appreciate if you could at least have a 
quick look at pfuse :)