[PATCH RFC 4/4] drm/msm/dp: Add support for LTTPR handling
Abel Vesa
abel.vesa at linaro.org
Thu Oct 31 15:12:48 UTC 2024
Link Training Tunable PHY Repeaters (LTTPRs) are defined in DisplayPort
1.4a specification. As the name suggests, these PHY repeaters are
capable of adjusting their output for link training purposes.
The msm DP driver is currently lacking any handling of LTTPRs.
This means that if at least one LTTPR is found between DPTX and DPRX,
the link training would fail if that LTTPR was not already configured
in transparent mode.
The section 3.6.6.1 from the DisplayPort v2.0 specification mandates
that before link training with the LTTPR is started, the DPTX may place
the LTTPR in non-transparent mode by first switching to transparent mode
and then to non-transparent mode. This operation seems to be needed only
on first link training and doesn't need to be done again until device is
unplugged.
It has been observed on a few X Elite-based platforms which have
such LTTPRs in their board design that the DPTX needs to follow the
procedure described above in order for the link training to be successful.
So add support for reading the LTTPR DPCD caps to figure out the number
of such LTTPRs first. Then, for platforms (or Type-C dongles) that have
at least one such an LTTPR, set its operation mode to transparent mode
first and then to non-transparent, just like the mentioned section of
the specification mandates.
Signed-off-by: Abel Vesa <abel.vesa at linaro.org>
---
drivers/gpu/drm/msm/dp/dp_display.c | 25 +++++++++++++++++++++++++
1 file changed, 25 insertions(+)
diff --git a/drivers/gpu/drm/msm/dp/dp_display.c b/drivers/gpu/drm/msm/dp/dp_display.c
index f01980b0888a40b719d3958cb96c6341feada077..5d3d318d7b87ce3bf567d8b7435931d8e087f713 100644
--- a/drivers/gpu/drm/msm/dp/dp_display.c
+++ b/drivers/gpu/drm/msm/dp/dp_display.c
@@ -107,6 +107,8 @@ struct dp_display_private {
struct dp_event event_list[DP_EVENT_Q_MAX];
spinlock_t event_lock;
+ u8 lttpr_caps[DP_LTTPR_COMMON_CAP_SIZE];
+
bool wide_bus_supported;
struct dp_audio *audio;
@@ -367,12 +369,35 @@ static int dp_display_send_hpd_notification(struct dp_display_private *dp,
return 0;
}
+static void dp_display_lttpr_init(struct dp_display_private *dp)
+{
+ int lttpr_count;
+
+ if (drm_dp_read_lttpr_common_caps(dp->aux, dp->panel->dpcd,
+ dp->lttpr_caps))
+ return;
+
+ lttpr_count = drm_dp_lttpr_count(dp->lttpr_caps);
+
+ if (lttpr_count) {
+ drm_dp_lttpr_set_transparent_mode(dp->aux, true);
+
+ if (lttpr_count > 0) {
+ if (drm_dp_lttpr_set_transparent_mode(dp->aux, false) != 1)
+ drm_dp_lttpr_set_transparent_mode(dp->aux, true);
+ }
+ }
+}
+
static int dp_display_process_hpd_high(struct dp_display_private *dp)
{
struct drm_connector *connector = dp->dp_display.connector;
const struct drm_display_info *info = &connector->display_info;
int rc = 0;
+ if (!dp->dp_display.is_edp)
+ dp_display_lttpr_init(dp);
+
rc = dp_panel_read_sink_caps(dp->panel, connector);
if (rc)
goto end;
--
2.34.1
More information about the Nouveau
mailing list