<html> <head> <base href="https://bugs.freedesktop.org/"> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - xorg-server-1.19.3 crashes when trying to enable HDMI output" href="https://bugs.freedesktop.org/show_bug.cgi?id=101220#c12">Comment # 12</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - xorg-server-1.19.3 crashes when trying to enable HDMI output" href="https://bugs.freedesktop.org/show_bug.cgi?id=101220">bug 101220</a> from <a class="email" href="mailto:imirkin@alum.mit.edu" title="Ilia Mirkin <imirkin@alum.mit.edu>"> Ilia Mirkin</a> <pre>(In reply to Pacho Ramos from <a href="show_bug.cgi?id=101220#c11">comment #11</a>) > I don't use any initrd... I could rely on CONFIG_EXTRA_FIRMWARE... but I > thought I didn't need that as nouveau is compiled as a module and not into > the kernel :| OK, well if modules are loaded off the FS and not initrd, then you're good on that front, assuming you really do have the updated linux-firwmare (April 4 or later -- <a href="https://git.kernel.org/pub/scm/linux/kernel/git/firmware/linux-firmware.git/commit/?id=b14134583c2a15d4404695f72cb523daedb877ab">https://git.kernel.org/pub/scm/linux/kernel/git/firmware/linux-firmware.git/commit/?id=b14134583c2a15d4404695f72cb523daedb877ab</a>). Lots of people use initrd without understanding how it works. So there are two issues here... #1: we should probably disable reverse prime if you don't have acceleration (or figure out how to make it work without accel... should just be a very slow memcpy away... not great, but better than a non-working screen) #2: we should figure out what's going on with accel on your GP107 -- looks like stuff is just hanging (that's the "timeout" messages you see, we're waiting for some condition to become true, and it never does). I can help with the former, and hopefully Ben Skeggs can investigate the latter.</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the assignee for the bug.</li> </ul> </body> </html>