<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - No mouse cursor (invisible) with dual monitors and DVI/VGA "Y" cable, no display on DVI" href="https://bugs.freedesktop.org/show_bug.cgi?id=94259#c8">Comment # 8</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - No mouse cursor (invisible) with dual monitors and DVI/VGA "Y" cable, no display on DVI" href="https://bugs.freedesktop.org/show_bug.cgi?id=94259">bug 94259</a> from <a class="email" href="mailto:knoppix1337@yahoo.com" title="Eric <knoppix1337@yahoo.com>"> Eric</a> <pre>Tested with current openchrome as of this date Current setup: Wyse Vx0LE lspci shows: [S3 Unichrome Pro] (rev 01), Dual HP LP2065 4:3 monitors, one DVI mode, one VGA mode (DVI/VGA "Y" adapter) 1600x1200 60hz. Kernel 3.2.0-101-generic Previously when you ONLY had the VGA connected, it would boot fine with mouse cursor present. When testing with the recent openchrome, the mouse cursor is not present when booted with ONLY the VGA connected. ARandR shows a NEW Output LVDS-1 as active. If you fool around till you can uncheck "Outputs> LVDS-1> Active" and Apply, you get the mouse back. LVDS-1 only haS 1 resoulution, 1600x1200. This board has some un-populated connector pads on it. I don't know if it is a false detection or if the board has some un-used hardware on it. When booted with BOTH VGA and DVI connected, it behaves as it did with previous versions as originally described, except that the LVDS-1 now shows up, but NOT "active"</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the assignee for the bug.</li> </ul> </body> </html>