[Openchrome-users] CN400 DVI output support

[Hadley Rich]

On Wed, 14 Feb 2007 21:58:26 you wrote:
> Hadley Rich wrote:
> > (WW) VIA(0): Panel on K8M800, PM800 or VM800 is currently not supported.
>
> Panel means laptop's panel here.

OK, so I guess I don't need to worry about that then.

> > While searching around on this I came across this post;
> >
> > http://wiki.openchrome.org/pipermail/openchrome-users/2007-January/002661
> >.html
> >
> > where the user appears to be using a DVI module with a SP8000E which I
> > believe has the same CN400 chipset as my board.
> >
> > Does anyone have any insights as to why it's working for that board but
> > not this one? Do I have a hope of getting this going or is it just not
> > going to happen at present?
>
> Reading all the thread gives insight on what to do. Did you tried to use
> a reduced blanking mode ?

Sorry, I should have been more specific. I'm not trying to do 1080 resolution, 
only 1366x768 which I didn't think needed reduced blanking. I can't actually 
get the TV to display anything, it goes to blue screen when X starts.

I read through the thread to see if there were any hints which I could use but 
I couldn't find any. I'll keep looking to see if I can figure it out.

Thanks for the reply,

hads

--