[Openchrome-users] CN400 DVI output support

[Xavier Bachelot]

Hadley Rich wrote:
> On Wed, 14 Feb 2007 21:58:26 you wrote:
>> Hadley Rich wrote:
>>> (WW) VIA(0): Panel on K8M800, PM800 or VM800 is currently not supported.
>> Panel means laptop's panel here.
> 
> OK, so I guess I don't need to worry about that then.
> 
>>> While searching around on this I came across this post;
>>>
>>> http://wiki.openchrome.org/pipermail/openchrome-users/2007-January/002661
>>> .html
>>>
>>> where the user appears to be using a DVI module with a SP8000E which I
>>> believe has the same CN400 chipset as my board.
>>>
>>> Does anyone have any insights as to why it's working for that board but
>>> not this one? Do I have a hope of getting this going or is it just not
>>> going to happen at present?
>> Reading all the thread gives insight on what to do. Did you tried to use
>> a reduced blanking mode ?
> 
> Sorry, I should have been more specific. I'm not trying to do 1080 resolution, 
> only 1366x768 which I didn't think needed reduced blanking. I can't actually 
> get the TV to display anything, it goes to blue screen when X starts.
> 
> I read through the thread to see if there were any hints which I could use but 
> I couldn't find any. I'll keep looking to see if I can figure it out.
> 
> Thanks for the reply,
> 
> hads
> 
Please give more details and materials to work with, like xorg.conf and 
xorg.log. Also please stay on list.

Regards,
Xavier