[Openchrome-users] Missing card ID
Cristian Busulari
cbusular
Mon Sep 17 04:33:32 PDT 2007
I had a motherboard branded Foxconn WinFast with chipset Via K8M890CE, I compiled Openchrome from
latest svn but it is not able to use a resolution higher than 800x600.
# lspci -vv
01:00.0 VGA compatible controller: VIA Technologies, Inc. Unknown device 3230 (rev 01) (prog-if 00
[VGA])
Subsystem: Foxconn International, Inc. Unknown device 0c84
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR-
FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR-
<PERR-
Latency: 0 (500ns min)
Interrupt: pin A routed to IRQ 5
Region 0: Memory at c0000000 (32-bit, prefetchable) [size=256M]
Region 1: Memory at dd000000 (32-bit, non-prefetchable) [size=16M]
[virtual] Expansion ROM at de000000 [disabled] [size=64K]
Capabilities: [60] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [70] AGP version 3.0
Status: RQ=256 Iso- ArqSz=0 Cal=7 SBA+ ITACoh- GART64- HTrans- 64bit- FW- AGP3+
Rate=x4,x8
Command: RQ=1 ArqSz=0 Cal=0 SBA+ AGP- GART64- 64bit- FW- Rate=<none>
---------------------------------------------
This are portions of Xorg logfile:
(II) VIA: driver for VIA chipsets: CLE266, KM400/KN400, K8M800,
PM800/PM880/CN400, VM800/CN700/P4M800Pro, K8M890, P4M900, CX700,
P4M890
(II) Primary Device is: PCI 01:00:0
(--) Chipset K8M890 found
(!!) VIA Technologies does not support or endorse this driver in any way.
(!!) For support, please refer to http://www.openchrome.org/ or
(!!) your X vendor.
(!!) (development build, at svn revision 396)
...
(EE) VIA(0): Unknown Card-Ids (105B| C84); please report to openchrome-users at openchrome.org
Thanks in advance.
Saludos
Cristian Busulari.
Segu? de cerca a la Selecci?n Argentina de Rugby en el Mundial de Francia 2007.
http://ar.sports.yahoo.com/mundialderugby
More information about the Openchrome-users
mailing list