[Openchrome-users] [Fwd: ] VX900 chipset and Debian

[ff at freddyfisker.dk]

Before installation of the OpenChrome driver the computer is using the
Vesa driver.

And after installation of the OpenChrome driver and restart, then there is
no signal on the monitor.

That is why I have made the via_regs_dump first from the terminal
<Ctrl><Alt>F1 and afterwards from the Vesa driver without restart.

I hope you can help me, because the Vesa driver have a maximum solution of
1280x1024 on the VGA-port and 800x600 on the HDMI-port.



> On 12/02/2012 12:57 PM, ff at freddyfisker.dk wrote:
>> I forgot to set the subject so I sent the mail again
>>
>> ---------------------------- Original Message
>> ----------------------------
>> Subject:
>> From:    ff at freddyfisker.dk
>> Date:    Sun, December 2, 2012 12:51 pm
>> To:      openchrome-users at lists.freedesktop.org
>> --------------------------------------------------------------------------
>>
>> Thanks for your help. The installation is the same, unless the
>> via_regs_dump -dpm command is made before restart, with the Vesa driver
>> running.
>>
> The registers dump would need to be done while openchrome is running,
> not with the vesa driver.
>
> Regards,
> Xavier
>
> _______________________________________________
> Openchrome-users mailing list
> Openchrome-users at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/openchrome-users
> Main page: http://www.openchrome.org
> Wiki: http://www.openchrome.org/trac/wiki/TOC
>