[packagekit] packagekit.progress.py

[zodman]

fix


        else:
              startpct = self.steps[self.current_step-1]
          if self.current_step < len(self.steps)-1:
-            endpct = self.steps[self.current_step+1]
+            endpct = self.steps[self.current_step]
          else:
              endpct = 100
          deltapct = endpct -startpct
          f = float(self.subpercent)/100.0
          incr = int(f*deltapct)
+        #print "delta: %s-%s *subp: %s/100 = inc:%.2f" %( 
endpct,startpct, self.subpercent, incr)
          self.percent = startpct + incr
+       # print self.percent



Richard Hughes escribió:
> On Wed, 2009-02-18 at 02:52 -0600, zodman wrote:
>> Im play with it but im confuse:
>>
>> from the code
>>
>> if i set progress.set_step( [10, 30, 50, 70] )
>>
>>
>> print start at 0% end 30% doing a progress.step() ( 100 prints )
>> then
>> start at 10% end 50% do a progress.step()
>>
>> start at 30% end 70% step()
>>
>> start at 50% end 100% step ()
>>
>> ??????????????????
>>
>> its that correct this ?¿
> 
> I'm not sure I understand, sorry (original code was written by Robin
> IIRC):
> 
> This code is used by apt, conary, pisi, smart, yum -- so what exactly
> does your patch change? Does anyone else have any comments?
> 
> Richard.
> 
> 
> _______________________________________________
> PackageKit mailing list
> PackageKit at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/packagekit