[pulseaudio-tickets] [Bug 39664] Kinect USB Audio device and module-alsa-card.c: Failed to find a working profile.

[bugzilla-daemon at freedesktop.org]

https://bugs.freedesktop.org/show_bug.cgi?id=39664

--- Comment #8 from Antonio Ospite <ospite at studenti.unina.it> 2011-09-07 13:43:10 PDT ---
OK, with the attached profile (kinect-audio.conf) and the proper udev rules
(55-kinect_audio.rules, using Drew's upload_fw), I have the device working fine
even when plugged _after_ pulseaudio has started.

The profile is very simple it just defines a 4 channels, input-only mapping on
hw:%f. Can this help you to understand what the cause of the original failure
with default.conf is? I found a possible cure, but I am still not sure about
what the cause of the problem was.

Is there still room for improvement about the channels names? I mean, am I
forced to use fixed names ( front-left, front-right, rear-left, rear-right), or
can I use something like Mic1, Mic2, Mic3, Mic4?

Regards,
   Antonio Ospite
   http://ao2.it

-- 
Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug.
You are the assignee for the bug.