[pulseaudio-discuss] Anyone seen this problem: Cards show up but their sinks/sources do not.
Lennart Poettering
lennart at poettering.net
Fri May 7 16:19:40 PDT 2010
On Mon, 03.05.10 09:03, Colin Guthrie (gmane at colin.guthr.ie) wrote:
> Hi,
>
> I come across this occasionally (usually when moving from home to my
> office where I have a USB speaker via a USB Hub.
>
> The card itself is shown fine and lets me choose the profiles etc., but
> it refuses to actually load any sinks/source for it.
>
> Changing profile doesn't seem to help kick it into gear and restarting
> PA is the only possible answer.
>
> I suspect it's something odd relating to not unloading properly which in
> turn prevents loading again or something similar, but I can't reproduce
> it at will sadly, so hard to say.
>
> I grabbed the attached debug.
>
> Doesn't tell me much other than the card loads OK, but the sinks/sources
> do not. I've not picked at the code yet to discover potential failure
> points, but figured I'd ask here as a first step.
>
The logs look as if the "off" profile is simply the one that is being
restored.
Could you reproduce this and the generated the debug output during a
profile switch that doesn't work? I.e. start up PA so that it is broken,
then begin logging, change the profile, stop logging. Then attach
logging here!
Lennart
--
Lennart Poettering Red Hat, Inc.
lennart [at] poettering [dot] net
http://0pointer.net/lennart/ GnuPG 0x1A015CC4
More information about the pulseaudio-discuss
mailing list