[pulseaudio-discuss] [PATCHv3 0/4] Read and store UCM data as proplist

[Graeme Gregory]

On 06/28/2011 11:46 PM, Colin Guthrie wrote:
> 'Twas brillig, and Alejandro Gonzalez at 28/06/11 23:22 did gyre and gimble:
>> Hi
>>
>> On Wed, 2011-05-18 at 01:22 -0500, Jorge Eduardo Candelaria wrote:
>>> On May 17, 2011, at 8:56 AM, Lu Guanqun wrote:
>>>
>>>> On Thu, May 12, 2011 at 02:56:04AM +0800, Jorge Eduardo Candelaria wrote:
>>>>> Ok, I'll copy the jack code we have into module-alsa-card. This will allow for simple jack removal/insertion events to be propagated to pulseaudio. We won't be able to do the complicated stuff mentioned above, but should at least be able to do simple speaker/headphone switching. 
>>>>
>>>> Hi Jorge,
>>>>
>>>> I'm interested in your jack detection code, when do you decide to send
>>>> it out? :-)
>>>
>>> Don't worry, I haven't forgotten about it :). I plan to send the new patches tomorrow
>>> if all goes well with testing.
>>>
>>> Regards,
>>> Jorge
>>
>> Is this UCM and jack detection code integrated on the PA git tree? If
>> not, is there any plan to do so, any time soon? (I don't mean to
>> pressure, is just that I didn't find any update in this matter, =))
> 
> The UCM stuff isn't merged yet as I'm kinda waiting on getting the jack
> detection stuff sorted out first (it's kinda a pre-requisite but we
> could ultimately shuffle things round in the short term).
> 
> The jack detection stuff is currently being discussed on alsa-devel now.
> We need to get this decided at a lower level (i.e. ALSA) before we can
> integrate support for it in PA.
> 
> But rest assured it is active work in progress.
> 

The two features should be independent of each other even if higher
levels might eventually use one to trigger state changes of the other.

It would be good to get the UCM stuff merged while waiting for Jack
discussion to settle.

Graeme