[pulseaudio-discuss] [PATCHv3 0/4] Read and store UCM data as proplist

[Colin Guthrie]

'Twas brillig, and Jorge Eduardo Candelaria at 18/05/11 07:22 did gyre
and gimble:
> 
> On May 17, 2011, at 8:56 AM, Lu Guanqun wrote:
> 
>> On Thu, May 12, 2011 at 02:56:04AM +0800, Jorge Eduardo Candelaria wrote:
>>> Ok, I'll copy the jack code we have into module-alsa-card. This will allow for simple jack removal/insertion events to be propagated to pulseaudio. We won't be able to do the complicated stuff mentioned above, but should at least be able to do simple speaker/headphone switching. 
>>
>> Hi Jorge,
>>
>> I'm interested in your jack detection code, when do you decide to send
>> it out? :-)
> 
> Don't worry, I haven't forgotten about it :). I plan to send the new patches tomorrow
> if all goes well with testing.

Have you spoken with David about this off-list by any chance?

As I mentioned previously, we have quite specific needs for jack
detection for it to be accepted so I hope further discussions have
happened or that you have managed to be super awesome and make it all
"just work" as we want it, otherwise more tweaks will be ultimately be
needed :)

Take care

Col

-- 

Colin Guthrie
gmane(at)colin.guthr.ie
http://colin.guthr.ie/

Day Job:
  Tribalogic Limited [http://www.tribalogic.net/]
Open Source:
  Mageia Contributor [http://www.mageia.org/]
  PulseAudio Hacker [http://www.pulseaudio.org/]
  Trac Hacker [http://trac.edgewall.org/]