[systemd-devel] After firmare
John Tobias
john.tobias.ph at gmail.com
Thu Dec 13 10:43:56 PST 2012
I renamed the /lib/firmware to /lib/firmware.old and reboot my system.
After rebooting it, I was getting an error (pls see below) that the
kernel did not find the firmware.
wl1271: ERROR could not get nvs file: -2
wl1271: loaded
wl1271: initialized
Then, if I do "ifconfig -a", the wlan0 interface is showing up.
On Thu, Dec 13, 2012 at 8:39 AM, Andrey Borzenkov <arvidjaar at gmail.com> wrote:
> В Wed, 12 Dec 2012 15:57:45 -0800
> John Tobias <john.tobias.ph at gmail.com> пишет:
>
>> ExecStart=/usr/sbin/wpa_supplicant -Dwext -iwlan0 -c/etc/wpa_supplicant.conf
>>
>> One of the problem was the systemd called the said script before the
>> kernel loads the firmware(/lib/firmware/TIInit_7.2.31.bts). I would
>> like to know if there's a way to determine if the firmware is already
>> loaded before the systemd execute the said service?.
>>
>
> Normally interface should appear only after firmware is loaded. So
> making your script depend on wlan0.device should do it.
>
> It may be a bit tricky to find correct dependency though. E.g. I have
>
> Id=sys-devices-pci0000:00-0000:00:1c.1-0000:0c:00.0-net-wlan0.device
> Names=sys-devices-pci0000:00-0000:00:1c.1-0000:0c:00.0-net-wlan0.device sys-subsystem-net-devices-wlan0.device
More information about the systemd-devel
mailing list