[systemd-devel] Service fails to start with no log messages

[Reindl Harald]

Am 07.01.20 um 03:56 schrieb Reindl Harald:
> 
> 
> Am 07.01.20 um 03:47 schrieb Jeffrey Walton:
>> On Mon, Jan 6, 2020 at 9:35 PM Reindl Harald <h.reindl at thelounge.net> wrote:
>>>
>>> Am 07.01.20 um 02:57 schrieb Jeffrey Walton:
>>>> To fix my ordering problem I need Systemd to stop lying about when the
>>>> network is ready.
>>>
>>> one last comment:
>>>
>>> whatever crap you did ending in the ordering cycle did not solve your
>>> wrong ordering after network, it just burried it by slow down something
>>> else and so by luck
>>>
>>> systemd does not lie here - you just need to do the ordering proper
>>> based on how your network is configured at all which you refuse to tell
>>>
>>> so your better options would have been report thate network ordering
>>> problem here before touch anything else
>>>
>>> "There are absolutely 0 entires about my monitor service" is because
>>> it's thrown out of the startup transaction cause dby your other config
>>> screwup
>>
>> And there we have it. Systemd is not logging the problem. And then you
>> wonder why users like me go down rabbit holes.
> 
> it does and common sense should tell you *fix that* and whatever you did
> introducing that issue by try to work aorund a completly different issue
> (network ordering) was simply bullhsit and has to be reverted
> 
> common sense should tell you that *every* error / warning should be
> adressed before try to debug something else further
> 
> Jan 06 20:25:33 raspberrypi systemd[1]: graphical.target: Job
> callboot-ui.service/start deleted to break ordering cycle starting with
> graphical.target/start

you comment alone shows the bullshit you are doing "It slows down the
boot so the service starts without failure" bsides that it obviously
don#t work "slow down the boot" is no solution for a problem

# This service waits for the UI. It slows down the
# boot so the service starts without failure.
After=graphical.target
Wants=graphical.target
# Service waits for the USB modem
After=usb.target
Wants=usb.target